Healthrider HREL8806.1 manual Repeat this step for the Right Handlebar not shown

8.Attach Inner and Outer Handlebar Covers (18, 19) around the Left Handlebar (8) with three M4 x 16mm Self-tapping Screws (79) and an M4 x 13mm Washer (93). Start all three Self-tapping Screws before tightening any of them.

Repeat this step for the Right Handlebar (not shown).

8

79

	8
		18
19	93	79

9.	Apply a generous amount of grease to the	9
	Pivot Axle (65), and insert the Pivot Axle into the
	Frame (2).
	Attach each Frame Cover (17) to the Frame (2)			2
	with two M4 x 16mm Screws (86).		Grease	65
			17	17
		86
10.	Apply a small amount of grease to both sides of	10
	a Wave Washer (98). Slide the Wave Washer
	onto the left end of the Pivot Axle (65). Next,			9
	slide the Left Handlebar (8) onto the Pivot Axle
	as shown. Attach the Left Handlebar with an
	M10 x 23mm Shoulder Screw (80) and an		8
	M10 x 20mm x 1mm Washer (81).			98
	Repeat this step for the Right Handlebar (9).
		81		65
		80		Grease
		9