Assembly

Before beginning assembly, carefully read the following information and instructions:

•Place all parts in a cleared area and remove the packing materials; do not dispose of the packing materials until assembly is completed.

•Read each assembly step before you begin.

•For help identifying the small parts used in assembly, use the part identification chart below. The number in parenthesis below each part refers to the key number of the part. The second number refers to the quantity needed for assembly. Note: Some small parts may have been pre-attached for shipping purposes. If a part is not in the parts bag, check to see if it has been pre-attached.

•Tighten all parts as you assemble them, unless instructed to do otherwise.

•During assembly, make sure that all parts are ori- ented as shown in the drawings.

THE FOLLOWING TOOLS (NOT INCLUDED) ARE REQUIRED FOR ASSEMBLY:

•Two (2) adjustable wrenches

•One (1) phillips screwdriver

•You will also need some lubricant, such as petroleum jelly or grease.

Assembly will be more convenient if you have the following tools: A socket set, a set of open-end or closed-end wrenches, or a set of ratchet wrenches.

Weight Tube Screw (54)–1		3/8” Pivot Bushing (41)–1
1/4” Flat Washer (57)–14	3/8” Flat Washer (55)–4		M9 Rubber Sheild Washer (58)–4
M6 Square Nut (4)–2	M6 Hex Nut (2)–6	3/8” Nylon Lock Nut (31)–1		M8 Acorn Nut (56)–4
M6 x 35mm Bolt (3)–2	M6 x 40mm Bolt (60)–6		3/8” x 1 3/8” Shoulder Bolt (61)–1
	M8 x 157mm Axle (59)–2
		4