To Adjust Back
Step 1.
Pull up on the wire behind the seat to fully recline it.
Step 2.
To Change to Swivel or Non-swivel Wheels
Front swivel wheels lock for use on uneven surfaces such as grass, stones or gravel.
Before locking swivels, first push stroller forward a few feet to ensure that the wheels are correctly positioned.
To Fold Stroller
Step 1.
Before folding stroller, fold canopy and recline seat. Apply brakes to prevent stroller from moving.
To Attach the Graco®
Safety Seat (on certain models)
Improper use of this stroller with a carrier may result in serious injury or death.
Do not use this stroller with a safety seat that is not the Graco® brand.
Read the owner’s manual provided with your Graco® safety seat before using the seat with this stroller.
After seat is fully reclined, lift seat upwards until it locks into one of the other positions.
Fabric caught in the latches may prevent them from locking. When returning seat to upright position, do not allow fabric to be pinched in the latch.
To Adjust Leg Rest
Push in the buttons at both sides of the leg rest. While holding buttons in, move leg rest up or down to desired position.
To Use Child’s Tray
Always secure your child with the seat belt. The child’s tray is not a restraint device.
DO NOT lift the stroller by the child’s tray.
Use care when clamping the child’s tray on the stroller with a child in the stroller.
Snap the child’s tray under the fold latch on both leg tubes as shown.
Slide DOWN for swivel. | Slide UP for |
To Use Parent’s Tray
To avoid burns, never put hot liquids in the parent’s tray. To prevent tipping over, do not place more than 3 lbs. (1.4 kg) on the parent’s tray.
Step 1.
Remove the two screws found on top of the stroller handle tubing just above the canopy. Do not remove canopy screws.
Step 2.
Fold the tray on its “hinge” several times to break in the hinge.
Hinge
Step 3.
Snap parent’s tray to stroller handle as shown. Reinsert screws, attaching tray to handle.
To Adjust Canopy
Push or pull canopy to desired position.
Step 2.
1.Slide red button on handle to the right.
2.Twist grip away from yourself until it stops.
3.Push stroller handle down.
Ë Ë
Ê 
Ì
OR
Pull latches up to release and fold handle down.
Step 3.
Close and lock storage latch.
If you do not have the owner’s manual for the Graco® safety seat, call Graco at
Make sure the stroller is fully assembled according to the preceding instructions.
Step 1.
If the stroller is folded, unfold it and RECLINE the stroller seat back to its lowest position.
Step 2.
Push down on the tray to be sure it is securely attached to the stroller.
Step 3.
If your child is already in the safety seat because you have been using it as a carrier, make sure child is secured with the harness.
Always secure your child with the safety seat harness when using the safety seat in the stroller.
Step 4.
Move the carrier handle into the carrying position.
Step 5.
Position the carrier so that the mounting notches fit over the edge of the arm bar or tray. Push down on carrier until the attachment latch snaps into the arm bar or tray.
See following page...
9 | 10 | 11 | 12 |