Huffy M732201 manual If Using Sand 2 Gallons of ANTI-FREEZE is not Required

Page 21

14. Roll the completed assembly to the desired playing area. Fill tank with 33 gallons of water.

WARNING!

TWO CAPABLE ADULTS

REQUIRED FOR THIS

PROCEDURE. FAILURE TO

FOLLOW THIS WARNING

COULD RESULT IN

SERIOUS INJURY AND/OR

PROPERTY DAMAGE.

24

24

WARNING!

DO NOT LEAVE

ASSEMBLY

UNATTENDED WHEN

EMPTY; IT MAY TIP

OVER.

SAND

 

lb

.

)

 

 

kg)

(360

 

 

 

 

 

(163

 

NOTE:

IF USING SAND: 2 GALLONS OF ANTI-FREEZE IS NOT REQUIRED

15. Apply the height adjustment and moving label (25) to the front of the pole as shown.

HEIGHT ADJUSTMENT

TO RESET OR

REPOSITION

BACKBOARD:

1.Grasp handle firmly and pull down to raise rim PAST highest position (above 10 feet).

2.While still holding handle firmly, CAREFULLY lower rim to lowest position.

3.Raise to desired height by pulling down on handle.

WARNING!

DO NOT ALLOW

CHILDREN TO

ADJUST HEIGHT.

HEIGHT ADJUSTMENT

CAUTION!

DO NOT LET GO OF HANDLE

UNTIL THE RIM IS RESET AT

LOWEST POSTION OR

DESIRED HEIGHT.

READ BEFORE

FAILURE TO FOLLOW THIS

OPERATING

WARNING COULD RESULT

ELEVATOR

IN SERIOUS INJURY AND/OR

SYSTEM

PROPERTY DAMAGE.

1.

2.

3.

TO RESET OR REPOSITION BACKBOARD:

1. Grasp handle firmly and pull down to raise rim PAST highest position (above 10 feet).

2. While still holding handle firmly, CAREFULLY lower rim to lowest position.

3. Raise to desired height by pulling down on handle.

 

 

1.

Adjust basketball

MOVING

 

backboard height to

 

lowest position.

SYSTEM

2. While holding pole,

 

 

 

rotate basketball

 

 

 

system forward until

 

 

 

wheels engage with

 

 

 

ground.

 

 

3.

Move basketball

 

 

 

system to desired

 

 

 

location.

 

 

4.

Carefully rotate

 

 

 

basketball system

 

 

 

upright.

 

 

5.

Check system for

 

 

 

stability.

522730

06/05

 

 

25

10ft.

(3.05 m)

21

01/06

ID# M732201

Image 21
Contents Write Model Number From Box Here Before YOU Start Moving Product Registration Get to know the basic parts of your basketball system Parts List See Hardware Identifier Hardware Identifier Bolts & Pins Item #7 Item #44 Section a Assemble the Base Align dimple of top pole into trough of middle pole as shown Dimple Hole Do not Over Orientation of Struts Section B Attach the Backboard TOP View Ratchet Assembly USE EYE Protection 01/06 ID# M732201 10. B 01/06 ID# M732201 Install Rim to Backboard If Using Sand 2 Gallons of ANTI-FREEZE is not Required