Spalding M8860411 manual Have Been Fully Tightened

Page 17

17. After pole has been secured to plate (2) loosen nut (25), remove cotter pin (37), and pull out pin (36). This will allow the removal of the assembly bolt (14) which is no longer necessary for the remainder of the assembly and installation of system.

WARNING: ONLY AFTER NUTS (25)

HAVE BEEN FULLY TIGHTENED:

Remove cotter pin (37) and pin (36) to remove assembly bolt (14) from bottom plate (2).

06/05

ID# M855441

Image 17

Contents In-Ground Basketball System Safety Instructions Parts List Hardware Identifier Bolts & Screws Make sure nuts 25 are 2.75 7 cm from top of J-bolts Build drainage hill Side ViewInsert bushings 27 into areas shown Mounting plate 2 as shown Playing SurfaceCompleted Assembly ID# M855441 06/05 Lower yoke Attach elevator adjustment 12 toAttach elevator adjustment 12 to pole bracket Attach backboard 10 to upper and lower Using TWO people to hold the boardYokes 18 First attach board 10 to upper yokeTo the top of the nut Figure a Attach height indicators Apply height indicator labels 32 & 31 to height indicatorsInstall net 4 to rim as shown To lower yoke in areaE Y C a FA L R P U S Have Been Fully Tightened Feet 3.05 m Limited Lifetime Warranty