Item | Qty | Description | Item | Qty | Description |
|
|
|
|
|
|
A | 4 | Button Head Cap Screw M10 X 2 | D | 4 | Lock Washer M10 |
|
|
|
|
|
|
B | 4 | Flat Washer M10 |
|
|
|
|
|
|
|
|
|
Fully tighten the hardware before you put the dumbbells into the installed dumbbell bases on the stand.
Maintenance
Equipment must be regularly examined for damage and repairs. The owner is responsible to make sure that regular maintenance is done. Worn or damaged components must be replaced immediately or the equipment removed from service until the repair is made. Only manufacturer supplied components can be used to maintain and repair the equipment.
This product, its packaging, and components contain chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. This Notice is provided in accordance with California’s Proposition 65. If you would like additional information, please refer to our Web site at www.nautilus.com/prop65
Adjustable Dumbbell Maintenance:
The adjustable dumbbell with SelectTech® techology is a very low maintenance product. However, you can use these instructions to keep the product in its best condition.
1.If your SelectTech® dumbbell handle assembly, plates or base become dirty, you can clean them with a cloth lightly dampened with warm water and a small amount of mild soap. Wipe dry with a separate cloth.
2.The adjustable dumbbell is internally lubricated and will not require more internal lubrication. The contact between weight plates and selection discs is not lubricated but has naturally low friction. Lubrication is usually not necessary. If you feel it is necessary to lubricate the weight plates and/or selection discs, use only a “food grade”silicon lubricant.
Do not use any solvents, harsh detergents, chemicals or bleach on this product - this can damage the materials, resulting in degradation of the product’s performance or strength.
Never attempt to disassemble the dumbbell handle or base assembly – the product is not designed to be user serviced. Doing so will void the manufacturers warranty. Contact Nautilus, Inc. directly for service.
Troubleshooting
Problem | Solution | |
|
|
|
Dumbbell handle does not fully go into base when no |
|
|
plates are attached. | 1. | Make sure that the adjustment knobs are set directly to the number 4. |
| 2. | Make sure that the weight plates are seated correctly in the base assembly. |
|
|
|
Dumbbell handle does not fully go into base when |
|
|
plates are attached. | 1. | Make sure that the plates that are still in the dumbbell base are in their correct spots and not moved to |
|
| different support slots. This may be blocking the dumbbell from fitting back into the base. |
|
|
|
6