Universal Remote Control THZ-100 owner manual Troubleshooting Thermostat On-ScreenNotifications

THZ-100 THERMOSTAT

Troubleshooting Thermostat On-Screen Notifications

There are notifications on screen for checking the filter, wireless, and network.

If you receive a Check Filter notification then replace the furnace filter and reset the filter notification as outlined above.

If you receive a Check Wireless notification then check the signal strength of the THZ-100. If the strength is not excellent then contact your dealer for more assistance.

If you receive a Check Network notification then check the network connection on the MRX Advanced Network System Controller main unit or contact your dealer for more assistance.

Resetting the THZ-100 hermostat

In the unlikely event that you need to reset your THZ-100 thermostat, in the center of the right side of the thermostat there is a small hole located below the vents. Place the end of a paperclip or other similar thin device into the hole to press the reset button.

Pressing the reset button one time momentarily power cycles the thermostat. The Universal Remote Control logo appears briefly and then normal thermostat operation resumes with all previous settings saved.

Press and hold the Up and Down buttons on the front of the THZ- 100, and press the reset button on the side of the unit. You can release the UP and Down buttons once the THZ-100 power cycles. A progress bar displays to show the Factory Default progress.

In addition, pairing to the MRX Advanced Network System Controller base unit will be erased and the thermostat will need to go through the discovery mode to re-establish communications.

Page 40