Universal Remote Control THZ-100 owner manual Resetting the Filter Reminder

THZ-100 THERMOSTAT

Resetting the Filter Reminder

If a filter reminder time was setup through the MRX Advanced Network System Controller when your thermostat was initially setup, then you will periodically get a Check: Filter message on the main screen of the thermostat.

To clear the Check: Filter message from the thermostat screen after the filter has been replaced; use the arrow keys to move the highlight bar to Filter Reminder.

Press the key below the OK key label in the smart-key label at the bottom right of the display to select this new information screen. If you decide to cancel the operation then press the key below the Go Back key label in the smart-key label at the bottom left of the display.

The display updates to show Filter Reminder Reset at the top of the screen and the following message in the center of the screen Your filter reminder is going to be reset. You will be notified in <X Months> to change it again. The X displays the number of months designated at the initial thermostat setup.

Press the key below the OK key label in the smart-key label at the bottom right of the display to reset the reminder. If you decide to cancel the operation then press the key below the Cancel key label in the smart-key label at the bottom left of the display.

Page 33