JVC MX-GT90 manual Mises en garde, précautions et indications diverses

Page 2

Warnings, Cautions and Others

Mises en garde, précautions et indications diverses

 

 

CAUTION

 

 

 

RISK OF ELECTRIC SHOCK

 

 

 

DO NOT OPEN

 

 

 

 

 

 

 

 

 

CAUTION:

TO REDUCE THE RISK OF ELECTRIC SHOCK,

 

DO NOT REMOVE COVER (OR BACK).

 

NO USER SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

The lightning flash with arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

For U.S.A.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

For Canada/pour le Canada

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT. ATTENTION: POUR EVITER LES CHOCS ELECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQUAU FOND.

For Canada/pour le Canada

THIS DIGITAL APPARATUS DOES NOT EXCEED THE CLASS B LIMITS FOR RADIO NOISE EMISSIONS FROM DIGITAL APPARATUS AS SET OUT IN THE INTERFERENCE-CAUSING EQUIPMENT STANDARD ENTITLED “DIGITAL APPARATUS,” ICES-003 OF THE DEPARTMENT OF COMMUNICATIONS.

CET APPAREIL NUMERIQUE RESPECTE LES LIMITES DE BRUITS RADIOELECTRIQUES APPLICABLES AUX APPAREILS NUMIRIQUES DE CLASSE B PRESCRITES DANS LA NORME SUR LE MATERIEL BROUILLEUR: “APPAREILS NUMERIQUES”, NMB-003 EDICTEE PAR LE MINISTRE DES COMMUNICATIONS.

WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

CAUTION

To reduce the risk of electrical shocks, fire, etc.:

1.Do not remove screws, covers or cabinet.

2.Do not expose this appliance to rain or moisture.

ATTENTION

Afin d’éviter tout risque d’électrocution, d’incendie, etc.:

1.Ne pas enlever les vis ni les panneaux et ne pas ouvrir le coffret de l’appareil.

2.Ne pas exposer l’appareil à la pluie ni à l’humidité.

Caution –– STANDBY/ON button!

Disconnect the mains plug to shut the power off completely.

The STANDBY/ON button in any position does not

disconnect the mains line. The power can be remote controlled.

Attention –– Commutateur STANDBY/ON button!

Déconnecter la fiche de secteur pour couper complètement

le courant. Le commutateur STANDBY/ON ne coupe jamais complètement la ligne de secteur, quelle que soit sa position. Le courant peut être télécommandé.

1.CLASS 1 LASER PRODUCT

2.DANGER: Invisible laser radiation when open and interlock failed or defeated. Avoid direct exposure to beam.

3.CAUTION: Do not open the top cover. There are no user serviceable parts inside the Unit; leave all servicing to qualified service personnel.

1.PRODUIT LASER CLASSE 1

2.ATTENTION: Radiation laser invisible quand l'appareil est ouvert ou que le verrouillage est en panne ou désactivé. Eviter une exposition directe au rayon.

3.ATTENTION: Ne pas ouvrir le couvercle du dessus. Il n'y a aucune pièce utilisable à l'intérieur. Laisser à un personnel qualifié le soin de réparer votre appareil.

G-1

Image 2
Contents MX-G70 Mises en garde, précautions et indications diverses Instructions for safe use About This Manual PrecautionsIntroduction Contents Front Panel Location of the Buttons and ControlsFront Panel Become familiar with the buttons and controls on your unitAUX button and lamp Display WindowSee pages in the parentheses for details 0Disc tray open/close CD1, CD2, and CD3 buttons 13, 14Disc number buttons CD1, CD2, and CD3 14 Remote ControlRemote Control CD 3´8button 9, 14Getting Started Supplied Accessories Connecting AntennasPutting the Batteries into the Remote Control FM antennaAM antenna Connecting SpeakersTurn the AM loop antenna until you have the best reception To connect an outdoor AM antennaClose the speaker terminals Connecting Other EquipmentCanceling the display demonstration On the unit onlyCommon Operations Turning On or Off the PowerSetting the Clock Selecting the SourcesReinforcing the Bass Sound Adjusting the VolumeTo turn down the volume level temporarily Selecting the Sound ModesTo use your own sound mode Creating Your Own Sound Mode Manual ModeOn the unit only Select one of the preset sound modes Tuning in a Preset Station Tuning in a StationPresetting Stations Listening to FM and AM BroadcastsPress the same 0 you have pressed in step Playing Back CDs CD/CD-R/CD-RWLoading CDs Repeat steps 1 to 3 to place other CDsPlaying Back the Entire Discs Continuous Play Basic CD OperationsProgram Play Prohibiting Disc Ejection Tray Lock Playing at Random Random PlayRepeating Tracks or CDs Repeat Play To exit from Random play mode, press Random againLocating the Beginning of a Song Music Scan Playing Back TapesPlaying Back a Tape Recording a Tape on Deck B To clean the heads, capstans, and pinch rollersRecording To protect your recordingCD Direct Recording To record on both sides Reverse ModeDubbing Tapes Press DubbingAuto Edit Recording Press CLOCK/TIMER again Using the TimersUsing Daily Timer How Daily Timer actually worksTurn 4/ ¢to set the volume level When selecting Tuner FM or Tuner AMWhen selecting CD Press SET/DISPLAY to complete the Daily Timer settingHow Recording Timer actually works Using Recording TimerSelect the preset station Unit enters preset station selecting modeOn the remote control only Press Sleep Using Sleep TimerTimer Priority Wait for about 5 seconds after specifying the time lengthTo clean the disc MaintenanceCleaning the unit Handling discsTroubleshooting SymptomSpecifications Speaker section SP-MXG70 MX-G70Amplifier section CA-MXG70 HOW to Locate Your JVC Service Center Limited Warranty AUDIO-1 0101MWMMDWJEM