JVC MX-GT90 manual Using the Timers, Using Daily Timer, Press CLOCK/TIMER again

Page 24

Using the Timers

There are three timers available — Daily Timer, Recording Timer, and Sleep Timer.

Before using the timers, you need to set the clock built in the unit. (See page 9.)

Using Daily Timer

With Daily Timer, you can wake to your favorite music or radio program. You can set the timer whether the unit is on or off.

How Daily Timer actually works

The unit automatically turns on, set the volume level to the preset level, and starts playing the specified source when the

on-time comes (the indicator flashes just before the on- time, and continues flashing while the timer is operating). Then, when the off-time comes (“OFF” flashes just before the off-time), the unit automatically turns off (on standby).

The Daily timer works everyday automatically.

If you do not want to use the Daily timer, turn off the Daily timer. (See “To turn on or off Daily Timer after its setting is done” on page 22.)

The timer setting remains in memory until you change it.

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

•To correct a mis-entry while setting the timer, press

CANCEL/DEMO.

On the unit ONLY:

1 Press CLOCK/TIMER repeatedly until “DAILY” appears on the display.

indicator lights up and DAILY (Daily Timer) indicator also starts flashing on the display.

•Each time you press the button, the timer setting modes change as follows:

DAILY ON TIME REC

Canceled Clock ON TIME setting

(See page 9.)

2 Press CLOCK/TIMER again.

“ON TIME” appears for 2 seconds, then the unit enters on-time setting mode.

Before you start...

•When using the tuner as the source to play —

–Make sure to select a desired station.

•When using a CD as the source to play —

–Make sure there is a CD on the selected disc number tray.

•When using a tape as the source to play —

–Make sure that a tape is in the deck whose deck indicator (A or B) is lit on the display.

–Make sure that the tape direction is correct.

•When using the external component as the source to play —

–Set the timer equipped on the external component at the same time.

3 Set the on-time you want the unit to turn on at.

1)Turn 4/ ¢ to set the hour, then press SET/DISPLAY.

2) Turn 4/ ¢to set the minute, then press SET/DISPLAY.

“OFF TIME” appears for 2 seconds on the display, then the unit enters off-time setting mode.

4 Set the off-time you want the unit to turn off (on standby) at.

1)Turn 4/ ¢ to set the hour, then press

SET/DISPLAY.

2)Turn 4/ ¢ to set the minute, then press

SET/DISPLAY.

The unit enters source selecting mode.

– 21 –

Page 23 Page 25
Image 24
Page 23 Page 25
Contents MX-G70 Mises en garde, précautions et indications diverses Instructions for safe use Precautions IntroductionAbout This Manual Contents Location of the Buttons and Controls Front PanelFront Panel Become familiar with the buttons and controls on your unitDisplay Window See pages in the parentheses for detailsAUX button and lamp 0Disc tray open/close CD1, CD2, and CD3 buttons 13, 14Remote Control Remote ControlDisc number buttons CD1, CD2, and CD3 14 CD 3´8button 9, 14Supplied Accessories Connecting Antennas Putting the Batteries into the Remote ControlGetting Started FM antennaConnecting Speakers Turn the AM loop antenna until you have the best receptionAM antenna To connect an outdoor AM antennaConnecting Other Equipment Canceling the display demonstrationClose the speaker terminals On the unit onlyTurning On or Off the Power Setting the ClockCommon Operations Selecting the SourcesAdjusting the Volume To turn down the volume level temporarilyReinforcing the Bass Sound Selecting the Sound ModesCreating Your Own Sound Mode Manual Mode On the unit only Select one of the preset sound modesTo use your own sound mode Tuning in a Station Presetting StationsTuning in a Preset Station Listening to FM and AM BroadcastsPlaying Back CDs CD/CD-R/CD-RW Loading CDsPress the same 0 you have pressed in step Repeat steps 1 to 3 to place other CDsPlaying Back the Entire Discs Continuous Play Basic CD OperationsProgram Play Playing at Random Random Play Repeating Tracks or CDs Repeat PlayProhibiting Disc Ejection Tray Lock To exit from Random play mode, press Random againPlaying Back Tapes Playing Back a TapeLocating the Beginning of a Song Music Scan To clean the heads, capstans, and pinch rollers Recording Recording a Tape on Deck B To protect your recordingTo record on both sides Reverse Mode Dubbing TapesCD Direct Recording Press DubbingAuto Edit Recording Using the Timers Using Daily TimerPress CLOCK/TIMER again How Daily Timer actually worksWhen selecting Tuner FM or Tuner AM When selecting CDTurn 4/ ¢to set the volume level Press SET/DISPLAY to complete the Daily Timer settingUsing Recording Timer Select the preset stationHow Recording Timer actually works Unit enters preset station selecting modeUsing Sleep Timer Timer PriorityOn the remote control only Press Sleep Wait for about 5 seconds after specifying the time lengthMaintenance Cleaning the unitTo clean the disc Handling discsTroubleshooting SymptomSpecifications MX-G70 Amplifier section CA-MXG70Speaker section SP-MXG70 HOW to Locate Your JVC Service Center Limited Warranty AUDIO-1 0101MWMMDWJEM
Top Page Image Contents