JVC MX-GT90 manual Connecting Speakers, Turn the AM loop antenna until you have the best reception

Page 10

AM antenna	Connecting Speakers

	ANTENNA	Vinyl-covered wire
		(not supplied)
1	AM EXT
1	AM LOOP

FM 75

COAXIAL

2

AM loop antenna (supplied)

1Connect the AM loop antenna to the AM

LOOP terminals as illustrated.

• If the AM loop antenna wire is covered with vinyl, remove the vinyl by twisting it as shown in the diagram.

2Turn the AM loop antenna until you have the best reception.

To connect an outdoor AM antenna

When reception is poor, connect a single vinyl-covered wire to the AM EXT terminal and extend it horizontally. (The AM loop antenna must remain connected.)

For MX-GT90 and MX-GT80:

DO NOT carry the speaker by holding the duct tube (on the top of the speaker).

		1		3
			2
		Red
	Speaker cords			Speaker cords
	(red/black)	SUBWOOFERS		(red/black)
	(red/black)	RIGHT	LEFT	(red/black)
		RIGHT	LEFT
	Black			Black
		RIGHT	LEFT
		MAIN
		SPEAKERS
		CAUTION: SPEAKER
		IMPEDANCE
		6	16
		Blue
		Speaker cords
		(blue/black)
	From front		From front
	right speaker		left speaker
	From right			From left
	subwoofer			subwoofer

For better reception of both FM and AM

•Make sure the antenna conductors do not touch any other terminals and connecting cords.

•Keep the antennas away from metallic parts of the unit, connecting cords, and the AC power cord.

– 7 –

Image 10

Contents MX-G70 Mises en garde, précautions et indications diverses Instructions for safe use Introduction PrecautionsAbout This Manual Contents Front Panel Location of the Buttons and ControlsFront Panel Become familiar with the buttons and controls on your unit AUX button and lamp Display Window See pages in the parentheses for details 0Disc tray open/close CD1, CD2, and CD3 buttons 13, 14Disc number buttons CD1, CD2, and CD3 14 Remote ControlRemote Control CD 3´8button 9, 14Getting Started Supplied Accessories Connecting AntennasPutting the Batteries into the Remote Control FM antennaAM antenna Connecting SpeakersTurn the AM loop antenna until you have the best reception To connect an outdoor AM antennaClose the speaker terminals Connecting Other EquipmentCanceling the display demonstration On the unit onlyCommon Operations Turning On or Off the PowerSetting the Clock Selecting the SourcesReinforcing the Bass Sound Adjusting the VolumeTo turn down the volume level temporarily Selecting the Sound ModesOn the unit only Select one of the preset sound modes Creating Your Own Sound Mode Manual ModeTo use your own sound mode Tuning in a Preset Station Tuning in a StationPresetting Stations Listening to FM and AM BroadcastsPress the same 0 you have pressed in step Playing Back CDs CD/CD-R/CD-RWLoading CDs Repeat steps 1 to 3 to place other CDsPlaying Back the Entire Discs Continuous Play Basic CD OperationsProgram Play Prohibiting Disc Ejection Tray Lock Playing at Random Random PlayRepeating Tracks or CDs Repeat Play To exit from Random play mode, press Random againPlaying Back a Tape Playing Back TapesLocating the Beginning of a Song Music Scan Recording a Tape on Deck B To clean the heads, capstans, and pinch rollersRecording To protect your recordingCD Direct Recording To record on both sides Reverse ModeDubbing Tapes Press DubbingAuto Edit Recording Press CLOCK/TIMER again Using the TimersUsing Daily Timer How Daily Timer actually worksTurn 4/ ¢to set the volume level When selecting Tuner FM or Tuner AMWhen selecting CD Press SET/DISPLAY to complete the Daily Timer settingHow Recording Timer actually works Using Recording TimerSelect the preset station Unit enters preset station selecting modeOn the remote control only Press Sleep Using Sleep TimerTimer Priority Wait for about 5 seconds after specifying the time lengthTo clean the disc MaintenanceCleaning the unit Handling discsTroubleshooting SymptomSpecifications Amplifier section CA-MXG70 MX-G70Speaker section SP-MXG70 HOW to Locate Your JVC Service Center Limited Warranty AUDIO-1 0101MWMMDWJEM