JVC MX-GT90 manual Introduction, About This Manual, Precautions

Page 4

Introduction

We would like to thank you for purchasing one of our JVC products. Before operating this unit, read this manual carefully and thoroughly to obtain the best possible performance from your unit, and retain this manual for future reference.

About This Manual

This manual is organized as follows:

•The manual mainly explains operations using the buttons and controls on the unit. You can also use the buttons on the remote control if they have the same or similar names (or marks) as those on the unit.

If operation using the remote control is different from that using the unit, it is then explained.

•Basic and common information that is the same for many functions is grouped in one place, and is not repeated in each procedure. For instance, we do not repeat the information about turning on/off the unit, setting the volume, changing the sound effects, and others, which are explained in the section “Common Operations” on pages 9 to 11.

•The following marks are used in this manual:

Gives you warnings and cautions to prevent from damage or risk of fire/electric shock. Also gives you information which is not good for obtaining the best possible performance from the unit.

Gives you information and hints you had better know.

Precautions

Installation

•Install in a place which is level, dry and neither too hot nor too cold — between 5˚C (41˚F) and 35˚C (95˚F).

•Install the unit in a location with adequate ventilation to prevent internal heat built-up in the unit.

•Leave sufficient distance between the unit and the TV.

•Keep the speakers away from the TV to avoid interference with TV.

DO NOT install the unit in a location near heat sources, or in a place subject to direct sunlight, excessive dust or vibration.

Power sources

•When unplugging from the wall outlet, always pull the plug, not the AC power cord.

DO NOT handle the AC power cord with wet hands.

Moisture condensation

Moisture may condense on the lens inside the unit in the following cases:

•After starting heating in the room

•In a damp room

•If the unit is brought directly from a cold to a warm place Should this occur, the unit may malfunction. In this case, leave the unit turned on for a few hours until the moisture evaporates, unplug the AC power cord, and then plug it in again.

Others

•Should any metallic object or liquid fall into the unit, unplug the unit and consult your dealer before operating any further.

•If you are not going to operate the unit for an extended period of time, unplug the AC power cord from the wall outlet.

DO NOT disassemble the unit since there are no user serviceable parts inside.

If anything goes wrong, unplug the AC power cord and consult your dealer.

– 1 –

Page 3 Page 5
Image 4
Page 3 Page 5
Contents MX-G70 Mises en garde, précautions et indications diverses Instructions for safe use Introduction PrecautionsAbout This Manual Contents Location of the Buttons and Controls Front PanelFront Panel Become familiar with the buttons and controls on your unitDisplay Window See pages in the parentheses for detailsAUX button and lamp 0Disc tray open/close CD1, CD2, and CD3 buttons 13, 14Remote Control Remote ControlDisc number buttons CD1, CD2, and CD3 14 CD 3´8button 9, 14Supplied Accessories Connecting Antennas Putting the Batteries into the Remote ControlGetting Started FM antennaConnecting Speakers Turn the AM loop antenna until you have the best receptionAM antenna To connect an outdoor AM antennaConnecting Other Equipment Canceling the display demonstrationClose the speaker terminals On the unit onlyTurning On or Off the Power Setting the ClockCommon Operations Selecting the SourcesAdjusting the Volume To turn down the volume level temporarilyReinforcing the Bass Sound Selecting the Sound ModesOn the unit only Select one of the preset sound modes Creating Your Own Sound Mode Manual ModeTo use your own sound mode Tuning in a Station Presetting StationsTuning in a Preset Station Listening to FM and AM BroadcastsPlaying Back CDs CD/CD-R/CD-RW Loading CDsPress the same 0 you have pressed in step Repeat steps 1 to 3 to place other CDsPlaying Back the Entire Discs Continuous Play Basic CD OperationsProgram Play Playing at Random Random Play Repeating Tracks or CDs Repeat PlayProhibiting Disc Ejection Tray Lock To exit from Random play mode, press Random againPlaying Back a Tape Playing Back TapesLocating the Beginning of a Song Music Scan To clean the heads, capstans, and pinch rollers RecordingRecording a Tape on Deck B To protect your recordingTo record on both sides Reverse Mode Dubbing TapesCD Direct Recording Press DubbingAuto Edit Recording Using the Timers Using Daily TimerPress CLOCK/TIMER again How Daily Timer actually worksWhen selecting Tuner FM or Tuner AM When selecting CDTurn 4/ ¢to set the volume level Press SET/DISPLAY to complete the Daily Timer settingUsing Recording Timer Select the preset stationHow Recording Timer actually works Unit enters preset station selecting modeUsing Sleep Timer Timer PriorityOn the remote control only Press Sleep Wait for about 5 seconds after specifying the time lengthMaintenance Cleaning the unitTo clean the disc Handling discsTroubleshooting SymptomSpecifications Amplifier section CA-MXG70 MX-G70Speaker section SP-MXG70 HOW to Locate Your JVC Service Center Limited Warranty AUDIO-1 0101MWMMDWJEM
Top Page Image Contents