Coleman 2000001590 manual Before you begin, Pole Descriptions, To Set Up Tent, To Attach Rainfly

HOOLIGANtm 3 Model 2000001590

Before you begin

Read all instructions before set up.

•Select a level site clear of rocks, branches, and other hard or sharp objects, to install your tent.

WARNING: Keep clear of overhead power lines.

•Do not set up your tent under trees because of potential lightning strikes or falling tree limbs in inclement weather.

•Secure with all stakes and guylines provided to prevent property damage or personal injury.

•For best results in windy conditions, position narrow end of tent into the wind.

•Enlist the help of at least one other person to assist you when it is time to assemble the tent.

Pole Descriptions

		Pole	Pole	Pole
Description	Qty.	Dia.	Repair Kit	Replacement Kit
Main Pole, black	2	8.5mm	5010000541	5010000547
Vestibule Pole, grey	1	8.5mm	5010000541	5010000547
Vent Pole, black	1	6.0mm	5010000639	5010000639
with pre-bent ferrules

To Set Up Tent

1.Unfold tent and spread out on a clean, level surface with the door facing perpendicular to the wind direction. Unzip door.

2. Assemble Main Poles by interlocking the black, shock-cord- ed, sections.

3. Insert Main Poles through sleeves in top of tent. (Fig. 1)

7. Assemble thin, black, shock-corded Vent Pole.
8. Insert Vent Pole through
	Sleeve		Vent Pole
sleeve at back of tent.
(Fig. 5)
9. Insert metal tip into
grommet. Go to opposite
		Back of Tent		Fig. 5
end of Vent Pole and
gradually apply pressure to
pole forming an arch then
insert metal tip into grommet.
(Fig. 6 & 6A)
6A				Fig. 6

To Attach Rainfly

1.Drape Rainfly over tent. Make sure seams on Rainfly are facing down and centered over poles and the vestibule is over to door of the tent. (Fig. 7)

NOTE: Hook and loop fasteners, located on seams of under - side of rainfly, should be centered over black poles.

Rainfly

Vestibule over Door

STITCH LINE

Back of Tent

Fig. 1

Door

Main

Pole

Front of Tent

Fig. 7

2.Fold Rainfly at front of tent back as shown in Fig. 8.

3. Assemble Vestibule Pole by interlocking the grey, shock- corded, sections.

Main	Sleeve	Sleeve
Pole

4.Insert one end of black main pole into pin on metal loop located at either end of tent. (Fig. 2)

5.Go to opposite end of Main Pole and gradually apply pressure to pole forming an arch. Insert pin into

the pole end (Fig. 2 & 3). Repeat for the remaining Main Pole.

4.Insert one end of grey Vestibule Pole into pin on metal loop located at either side of tent. (Fig. 8 & 8A)

5.Go to opposite end of Vestibule Pole and gradually apply pressure to pole forming an arch. Insert pin into the pole end (Fig. 8 & 8A).

Grey Vestibule Pole

Hook & Loop

Stake

Fig. 3

	Main
	Pole
	Metal
	Loop
Fig. 2	& Pin

Stake

Fasteners

Door

Front of

Tent

Fig. 8

6.Stretch out corners and sides of tent. Drive in stakes at an angle through the metal loops to help anchor the corners & sides of the

tent. (Fig. 3 & 4) Fig. 4

8A

(continued on other side)