JVC MX-J111V CD Direct Recording, Tape to Tape Recording Dubbing, How to Use the Dubbing Button

Page 32

English

REPEAT

CD REC START

CD

SELECT

FM/AMAUX

TAPE

DUBBING

To pause at any time during the recording process

Press the REC PAUSE button on the Remote Control. Then press either the 2 or 3 button on the Remote Control or REC START/STOP button on the Unit to restart recording.

To stop at any time during the recording process

Press the REC START/STOP button on the Unit again, or press the 7button on the Remote Control.

Recording AM station to tape

When recording an AM broadcast, beats may be produced which are not heard when listening to the broadcast. In this case, press the REPEAT button on the CD Player to eliminate the beats.

1.Set to AM station and start recording.

2.Press the REPEAT button to eliminate the beats.

Each time you press the button, the display changes as shown below:

= CUT-1= CUT-2= CUT-3= (back to the beginning)

CD Direct Recording

Everything on the CD goes onto the tape in the order it is on the CD, or according to the order you have set in a program.

1. Prepare CDs. (Refer to “Inserting Discs” on page 14.)

If the current playing source is not the CD player, press CD £/8, then 7of the CD control before going to the next step.

2.Insert a cassette in Deck B to record on.

When you want to record on both sides of a tape, press the REV. MODE to turn Reverse mode on. Check that the recording direction for the tape and the Tape Direction indicator are correct. (See page 26 “Notes for using Reverse mode for recording”.)

3.Press the CD REC START button.

The “REC” indicator light comes on and the System begins recording.

If you make a recording with Reverse mode on:

If the tape reaches its end while recording a song, the last song will be re-recorded at the beginning of the other side.

To stop at any time during the recording process, press the 7button.

Note: When making Sleep timer settings while doing CD Direct recording, set the time so that there is enough leeway to finish the recording before the power goes off. If the time is set to about the length of the CD, the power may go off before recording finishes.

For CD Direct Recording using more than one disc, use a blank tape. If you use a prerecorded tape, prerecorded material may not be erased between newly-recorded tracks.

Tape to Tape Recording (Dubbing)

Recording from one tape to another is called dubbing. You can dub tapes simply, with just a single button.

o When dubbing tapes, make sure that the playback direction of Deck A and Deck B are the same.

oWhen you want to record both sides of a tape, press the REV. MODE button to turn Reverse mode on. o It is preferable that the type of tape (Type I or Type II) you record from be the same as the type you

record onto.

How to Use the DUBBING Button —————————————

1.Press the TAPE “ £ button, then the 7 button.

2.Insert the source cassette you want to copy from into Deck A for playback.

Insert the cassette so that it will be played in the forwards 3direction.

3.Insert the blank or erasable cassette you want to copy onto into Deck B for recording.

Insert the cassette so that it will be recorded in the forwards 3direction.

4.Press the DUBBING button.

Deck A and Deck B will start simultaneously.

To stop dubbing, press the 7button or the REC START/STOP button.

oWhen doing dubbing with the DUBBING button, you can hear Sound Mode effects through the speakers or headphones. However, the sound is dubbed without Sound Mode effects.

27

Page 31 Page 33
Image 32
Page 31 Page 33
Contents MX-J111V Precaución -- Interruptor Precaução -- InterruptorPrecaución PrecauçãoCA-MXJ111V Precaución el aparato debe estar bien ventiladoPrecaução Ventilação adequada Class Laser Product Features Installation of the UnitPower cord How This Manual Is OrganizedTable of Contents Accessories Set the Voltage Selector SwitchHow to Put Batteries in the Remote Control Using the Remote ControlConnecting the FM Antenna Connecting the AM AntennaUsing the Supplied Wire Antenna Using an FM 75 Ohm Antenna Wire not suppliedConnecting the Speakers Connecting Auxiliary EquipmentWhen you connect the Unit to TV Connect TV to Video OUTConnecting the Video Out Setting Video OutputUsing the Video Cord On the TV screenCompu Play Turning the Power On and Off Common OperationsDisplay Turning the System OnSound Modes Adjusting the VolumeReinforcing the Bass Sound Set the Volume control to Press the AUX button Listening to Auxiliary EquipmentOne Touch Radio Using the TunerSetting the AM Tuner Interval Spacing Tuning in a Station Presetting StationsChanging the FM Reception Mode Switching between Frequency BandsThis Unit can play the following CDs Using the CD PlayerDisc display Inserting Discs Quickest Way to Start a CD Is with the One Touch OperationPlace a CD, with its label side up, onto the tray CorrectincorrectBasics of Using the CD Player Normal Play Locating a Track with the Remote Control DirectlyPlaying a Disc Selecting a Disc, Track or Passage within a TrackProgramming the Playing Order of the Tracks Select a disc withCD1, CD2 or CD3 button Disc number Step numberRandom Play Repeating a Selection or the DiscsPress the Random button while the CD player is stopped Press the Repeat button on the unitTray Lock Function Locking the Electronic LockUnlocking the Electronic Lock UnitPlaying Video CDs and CD-Gs Special Plays for Video CDsFrame-by-Frame Playback Viewing Operation StatusTo stop and cancel the video intro, press the 7button To stop and cancel the highlight, press the 7buttonViewing the Video Intro of a Video CD Viewing the Highlights of a Video CDPlaying Video CDs with Using Menu Screens Playing Video CDs with PBC FunctionPrepare Video CDs Start playback of the Video CDConcept of PBC Flow Playing Video CDs without Using Menu ScreenPrepare a Video CD Using the Cassette Deck Tape £ Deck A/B REV. ModeTape Direction Indicator on the Display Regular PlayReverse Mode Music ScanFast Left and Fast Right UP Finding the Beginning of the Current SelectionThings to Know Before You Start Recording DubbingREC Pause REC START/STOPStandard Recording Recording Any Sound Source to TapeCheck the recording direction for the tape Press the 2 or 3 buttonTape to Tape Recording Dubbing How to Use the Dubbing ButtonCD Direct Recording Using the Timer Setting the ClockPress the Select + or button to set the time Press the SET buttonSetting the Timer Setting the Sleep Timer = 10 =20 = 30 =60 = 90 = 120 = CanceledTo Change the Sleep Timer Setting To Cancel the Sleep Timer SettingUsing the Microphone Playing the Microphone Sound through the SpeakersEcho MIC LevelApplying Echo to Your Vocal Pressing down the Shift button on the Remote ControlMicrophone Mixing Adjusting Key Control Singing Along with Multiplex Karaoke Discs or TapesMultiplex Sound Vocal ReplaceCare and Maintenance Compact Discs Cassette TapesMoisture Condensation Cassette DeckTroubleshooting SymptomPossible Cause ActionSpecifications JVC 0899KSMMDWHIT
Top Page Image Contents