Cateye MSC-2Dx Lap Feature, Recording Lap Data, Lap Data Read Out, Downloading Lap Data

LAP	LAP
START
0.00.00

TM

LP-01 LP-02 LP-03

Lap interval longer than 5 sec. Up to about 27 hrs.

Lap Feature

Up to 50 lap data points can be captured (Elapsed Time, Average Heart Rate for the lap, [Average Speed for the lap] and Trip Distance) and stored in memory for manual review or downloading to a PC with an interface unit.

Recording Lap Data

LAP

In any of the main or sub functions, push the LAP button. The beep sound goes off and the lap data is saved. At the same time, the lower display indicates the current lap number for about 3 seconds.

NOTE !: You must wait a minimum 5 seconds before recording next lap. The maximum measurable time is 27 hours and 46 minutes.

‘Beep’	Because the lap data captured is the average heart rate and average speed for the
	interval, short lap intervals may produce inconsistent data.

Lap number display for 3 sec. NOTE !: Lap data can be recorded even if Elapsed Time TM is not running (=stop state). However, once you record the lap data in the Stop State, next lap data cannot be recorded unless current speed gets started. The reset operation erases all lap data points.

	Lap Data Read Out
	To review the lap data:
	TM	Elapsed Time is not running. (=stop state)
	STOP
	1. Navigate to where the Lap Count LP is in the lower display.
SET/AT	2.	Push SET/AT button.
		The lap number is shown in the lower display for 1 second, and the screen starts to
	MODE
		readout the lap data.
Switching TM/DST		The upper display indicates Average Speed, the middle display indicates Average Heart Rate
	LAP	and the lower display indicates Elapsed Time with the flashing TM icon. To switch the lower
		display between Elapsed time TM and Trip distance DST, hold down the MODE button.
		NOTE !: The data of heart rate and speed shown here is the average value of
Lap data readout screen	Downloading	the interval between the two points.

LAP	MODE
	The next
	lap data
SET/AT

If you hold down LAP button for 2 seconds, the unit starts to download the data and the readout screen is fast-forwarded automatically. The screen continues fast-forwarding until the download is finished.

3.Continue the readout.

Push LAP button to move to the next lap data. Push MODE button to return to the prior lap data.

NOTE !: Each lap number appears in the lower display for 1 second.

NOTE !: If you hold down LAP button, the unit starts downloading. If you have started to download by mistake, it can be stopped by pressing the Lap button again.

4.When you have finished reviewing the Lap data, push SET/AT button and the screen returns to the Lap Count LP display.

Downloading Lap Data

The recorded lap data can be downloaded to a PC through the optional interface unit and e-train data software. See the download manual for details.

MSC-2Dx 15