8. Connect | the Upper Wire Harness (36) to the Lower | 8 | |
Wire Harness (65). Attach the Upright (13) to the |
| ||
Frame (1) with three M8 x 25mm Button Screws (33) |
| ||
and three M8 | Split Washers (59). Be careful to avoid |
| |
pinching | the | Wire Harnesses. | 13 |
|
|
| |
|
|
| 36 |
\
\
,Identify the Left Pedal (24), which is marked with an
"L." Using an adjustable wrench, firmly tighten the Left Pedal counterclockwise into the left arm of the
Crank (31). Tighten the Right Pedal (not shown) clock- | 31 | |
wise into the right arm of the Crank. Important: | 25 | |
Tighten | both Pedals as firmly as possible. After | |
using the exercise cycle for one week, retighten |
| |
the Pedals. For best performance, the Pedals must |
| |
be kept | tightened. |
|
Adjust the left Pedal Strap (25) to the desired position, and press the end of the Pedal Strap onto the tab on the Left Pedal (24). Adjust the right Pedal Strap (not
shown) in the same way.
24
Tab
10.Make sure that all parts are properly tightened before you use the exercise cycle. Note: After assembly is completed, some extra parts may be left over. Place a mat beneath the exercise cycle to protect the floor.
7