Assembly

Assembly requires two persons. Place all parts of the recumbent cycle in a cleared area and remove the pack- ing materials. Do not dispose of the packing materials until assembly is completed.

Assembly requires the included tools and your own adjustable wrench .

Use the drawings below to identify the small parts used in assembly. The number in parenthesis below each drawing refers to the key number of the part, from the PART LIST on page 14. The second number refers to the quantity needed for assembly. Note: Some small parts may have been pre-attached for shipping. If a part is not in the parts bag, check to see if it has been pre-assembled.

M6 Nylon	M6 Split	M6 Flat	M8 Flat Washer	M10 Split
Locknut (71)–4	Washer (57)–4	Washer (67)–4	(89)–4	Washer (87)–4

M4 x 16mm	M6 x 12.7mm	M6 x 35mm
Screw (64)–1	Button Screw (62)–4	Screw (70)–4

M6 x 16mm	Console	M10 x 25mm
Button Screw (68)–8	Screw (63)–4	Screw (88)–4

1.Attach the Stabilizer (8) to the Frame (1) with four M10 x 25mm Screws (88) and four M10 Split Washers (87).

	1
	1	8
	1	87
		87
		87
		88