Viper Viper 315-00109 owner manual Assembly

Page 11

Assembly

Figure 9

Step 1:

Locate console (F), and connect sensor wires (E5, A25, A26, E6, E7) to the wires coming from the console.

Step 2:

Gently push all of the wires into the con- sole tube. Slide console onto the console tube. Secure using two screws (F1).

Note: Screws (F1) will already be attached on the backside of the console. Remove before sliding onto console tube.

Figure 9

F

Figure 10

Step 1:

Thread the right pedal (L-R) into the right crank area of main frame (A1). Secure in place by turning it clockwise to tighten. Note: Right pedal (L-R) is marked with an “R”.

Step 2:

Thread the left pedal (L-L) into the left crank area of main frame (A1). Secure in place by turning it counter-clockwiseto tighten.

Note: Left Pedal (L-L) is marked with an “L”

Figure 10

11

Image 11
Contents Customer Service 1.800.750.IRON Table of Contents Safety Precautions and Tips Important Safety InformationConsole Parts Identifier Instructions for AssemblyParts Identifier Step AssemblyAssembly N10 Assembly Assembly Congratulations Console Buttons Console InstructionsConsole Functions Buttons on Upright HandlebarManual Program General InformationGetting Started Program InstructionsHeart Rate Program HRC ProgramsUser Program Program Profiles Monitoring Your Heart Rate Monitoring Your Heart RateWarm Up Exercises General Instructions Moving Instructions Viper Recumbent Bike Parts List Rev B Parts ListView ExplodedResidential and Personal Use Limited Warranty Warranty Information