Viper Viper 315-00109 owner manual N10

Page 9

Assembly

Figure 5

Step 1:

Slide the seat adjustment handlebar (A11) into the main frame and secure using stop- ping screw (N10).

Step 2:

Connect sensor wire (A32) to sensor wire (J1) and side handlebar (J-R) onto sliding track (A9). Secure using three bolts (N7).

Figure 5

A9

N10

Figure 6

Step 1:

Connect sensor wires (A32) to sensor wire (J1) and side handlebar (J-L) onto sliding track (A9). Secure using three bolts (N7).

Step 2:

Locate seat pad (G) and secure onto slid- ing track (A9) with four screws (N1) and four washers (N3).

Note: Screws are attached underneath seat pad.

Figure 6

N3

A9

Image 9
Contents Customer Service 1.800.750.IRON Table of Contents Safety Precautions and Tips Important Safety InformationConsole Parts Identifier Instructions for AssemblyParts Identifier Step AssemblyAssembly N10 Assembly Assembly Congratulations Console Buttons Console InstructionsConsole Functions Buttons on Upright HandlebarGetting Started General InformationProgram Instructions Manual ProgramPrograms User ProgramHeart Rate Program HRC Program Profiles Monitoring Your Heart Rate Monitoring Your Heart RateWarm Up Exercises General Instructions Moving Instructions Viper Recumbent Bike Parts List Rev B Parts ListView ExplodedResidential and Personal Use Limited Warranty Warranty Information