Spirit XR895, XU875 owner manual Seat & Handle BAR Assembly

Page 11

STEP 3: SEAT & HANDLE BAR ASSEMBLY

1.Install the Seat Cushion (61) on the Seat Carriage (4) with the 4pcs of M6x15mm Phillips Head Screws (98).

2.Install the Handle Bar (6) onto the Seat Carriage (4) with the 4pcs of 3/8 x 1-3/4 Hex Head Bolts (71), 4pcs of 3/8 x 19x1.5T Flat Washers (77), and 4pcs of 3/8 x 7T Nyloc Nuts (89) by using the 12/14mm Wrench (112).

3.Then plug the Hand pulse Cables (27~3)(27~4) into the sockets located on the left side rear cover (26), just under the seat. It does not matter which connector plugs into which socket.

4.Install the Front Stabilizer Cover (32) and the Rear Stabilizer Cover (37) on the Main Frame with the 4pcs of M5x12mm Phillips Head Screws (99).

10	XU875 & XR895

Image 11

Contents Page Table of Contents Product Registration Important Safety Instructions Important Operation Instructions Important Electrical InformationStep Assembly Pack Check List XR895Step Tools Unpacking the Unit Assembly Instructions XR895Rear Stabilizer & Seat Back Assembly Console Mast Assembly Seat & Handle BAR Assembly Release Lever Assembly Assembly Pack Check List XU875 #100 /14m/m Wrench 1 pc #92 /15m/m Wrench 1 pc Rear Stabilizer Assembly Assembly Instructions XU875Front Console Mast Assembly Handle BAR Assembly Console and Plastic Parts Assembly XU875 & XR895 Transportation FeaturesFoot pedals Operation of Your Stationary Bike XR895 & XU875 Console Power onBasic information Quick StartProgramming the console Entering/Changing SettingsManual Preset ProgramsFat Burn ProgramsCardio Interval StrengthCustom User Defined Programs XU875 & XR895 XU875 & XR895 XU875 & XR895 Rate of Perceived Exertion Erratic Operation Using a Heart Rate TransmitterAuto-pilot Heart Rate Control Program 1 & 2 HR 1, HR 2 operationBike Warranty Manufacturer’s Limited Warranty