Assembly Instructions (XR895)
UNPACKING THE UNIT
1.Cut the straps then lift the carton off.
2.Carefully remove all parts from carton and inspect for any damage or missing parts. If damaged parts are found, or parts are missing, contact your dealer immediately.
3.Locate the hardware package. The hardware is separated into four steps. Remove the tools first. Remove the hardware for each step as needed to avoid confusion. The numbers in the instructions
that are in parenthesis (#) are the item number from the assembly drawing, for reference.
STEP 1: REAR STABILIZER & SEAT BACK ASSEMBLY
1.Install the Rear Stabilizer (7) onto the Main Frame with the 4pcs of 3/8 x
2.Install Seat Back Frame (5) onto the Seat Carriage (4) with the 2pcs of 3/8 x 4 Hex Head bolts (67), 3/8 Flat Washers (77) and 3/8 Nyloc nuts (89) by using the 12/14mm Wrench (112). Tighten the bolts snugly enough so the seat back has no play but does not bind when reclining.
8 | XU875 & XR895 |