ASSEMBLY
Assembly requires two persons. Place all parts of the exercise | cycle in a cleared area | and remove | the packing | |||
materials. Do not dispose of the packing materials | until assembly | is completed. | Assembly | requires | the includ- | |
ed tools and your own adjustable wrench _, | Phillips screwdriver | _ | _, | and | ||
pliers _. |
|
|
|
|
|
|
Use the drawings below to identify the small parts used for assembly. The number in parentheses below each drawing is the key number of the part, from the PART LIST on page 14. The number following the key number is the quantity needed for assembly. Note: Some small parts may have been preassembled. If a part is not in the parts bag, check to see if it has been preassembled.
M4 x 25mm Round | M8 Split | M8 Nylon | M6 x 15mm Button | M8 x 15mm Sutton |
Head Screw | Washer | Locknut | Screw | Screw |
M8 x 60mm Button | M8 x 73mm Sutton |
Screw | Screw |
1.Insert the Rear Stabilizer (6) into the Frame (1). Attach the Rear Stabilizer with four M8 x 60mm Button Screws (30).
2. Orient the Front Stabilizer (2) with the large holes facing the Frame (1). Attach the Front Stabilizer to
30
33
the Frame with two M8 x 73mm Button Screws (33).
Large Holes 1