8.While a second person holds the Console (16) near the Upright (13), connect the console wire to the Extension Wire (23). Then, insert the wires down- ward into the Upright.
16
Attach the Console (16) to the Upright (13) with four M6 x 15mm Button Screws (46). Be careful to avoid pinching the wires.
23
Console
Wire
46
Be careful to
avoid pinching the wires.
9.Identify the Left Pedal (24), which is marked with a "Left" sticker. Using an adjustable wrench, firmly tighten the Left Pedal counterclockwise into the left arm of the Crank (21). Tighten the Right Pedal (not shown) clockwise into the right arm of the Crank. Important: Tighten both Pedals as firmly as pos- sible. After using the exercise cycle for one week, retighten the Pedals. For best performance, keep the Pedals tightened.
Adjust a Pedal Strap (3) to the desired position, and press the end of the Pedal Strap onto the tab on the side of the Left Pedal (24). Adjust the other Pedal Strap (not shown) in the same way.
21
24
10.Make sure that all parts are properly tightened before you use the exercise cycle, Note: After assembly is completed, some extra parts may be left over. Place a mat beneath the exercise cycle to protect the floor.
7