COMPUTER INSTRUCTIONS
OPERATION DESCRIPTIONS
1. To stop a running program, press the START / STOP button. In this mode, you can press the START / STOP button again to continue to run the current program. Or, you can use "
/
" buttons to select a new program. The function values of DISTANCE and CALORIE will continue to accumulate.
2. When you complete a program, press the START / STOP button to stop the program. You can use "
/
" buttons to select a new program. The function values of DISTANCE and CALORIE will continue to accumulate. This will allow you to run several programs and still know the total DISTANCE and CALORIE during the workout.
3.If you want to restart with a new program, press the RESET button to reset all of the function values to zero. Use "
/
" buttons to select a new program.
4.The computer will shut off automatically after 4 minutes of inactivity, and the function values, DISTANCE and CALORIE, will be kept.
POWER SOURCE:
The computer uses the ADAPTER(105) as a power source. Use the Magnetic Fusion 7200 Bike with the adapter plugged into an electrical outlet.
NOTE: Batteries are not required in the compartment on the back of the COMPUTER(27) of the Magnetic
Fusion 7200 Bike.
STORAGE
1.To store the Magnetic Fusion 7200 Bike, simply keep it in a clean dry place.
2.Adjust the SEAT FRAME(8) to the lowest position. The Magnetic Fusion 7200 Bike is approximately 53 1/4 inches long (min.) x 24 1/2 inches wide x 51 3/4 inches tall. These dimensions will vary. Please measure your Magnetic Fusion 7200 Bike if exact dimensions are needed.
3.To move the Magnetic Fusion 7200 Bike, lift the REAR STABILIZER(6) and the bike will roll on the WHEEL(62) on the FRONT STABILIZER(2).
MAINTENANCE
The safety and integrity designed into the Magnetic Fusion 7200 Bike can only be maintained when the Magnetic Fusion 7200 Bike is regularly examined for damage and wear. Special attention should be given to the following:
1.Use the UP and DOWN buttons on the COMPUTER(27) to select a program and verify that the Magnetic System provides different tensions. The Magnetic System should provide many years of use.
2.Use a wrench to verify that the pedals are tightened securely. If tightening is required, remember that the left pedal has left hand threads and is tightened by turning counterclockwise. The right pedal has right hand threads that are tightened by turning clockwise.
3.Verify that the WARNING LABEL(109) is in place and easy to read. Call Stamina Products immediately at
4.It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
5.Worn or damaged components shall be replaced immediately or the Magnetic Fusion 7200 Bike removed from service until repair is made.
6.Only Stamina Products supplied components shall be used to maintain/repair the Magnetic Fusion 7200 Bike.
7.Keep your Magnetic Fusion 7200 Bike clean by wiping it off with an absorbent cloth after use.
19