ADVANCED PRODUCT FEATURES
Jam BlockerTM #MPDLTKBNTCFGPSF they start
Stops shredding immediately when hands touch the paper opening
Energy Savings System Optimal energy efficiency 100% of the time – in use and out of use
JAM BLOCKERTM
#MPDLTKBNTCFGPSFUIFZTUBSU12
If Remove Paper icon ( ) is | 3FEVDFQBQFSRVBOUJUZUP |
illuminated, there is too much paper | an acceptable amount and |
for the shredder to power through | refeed into paper entry |
If Remove Paper icon illuminates during the shredding process (due to paper misfeed or wrinkle) follow the procedures below.
123
Shredder pauses for | Set to Reverse ( | ) | Set to Auto On ( | ) and |
3 seconds | and remove paper |
| refeed into paper entry |
SAFESENSE® TECHNOLOGY
Stops shredding immediately when hands touch the paper opening.
|
|
| |
1 | 2 | 3 | 4 |
Set to | ) | 5PVDIUFTUBSFBBOE | SafeSense® is active and | If hand is held on SafeSense® |
|
| look for the SafeSense® | working properly | area more than 3 seconds |
|
| indicator to illuminate |
| shredder will shut off |
ENERGY SAVINGS SYSTEM
Optimal energy efficiency 100% of the time – in use and out of use.t 4BWFTFOFSHZJOGPVSXBZTFOFSHZFGGJDJFOUFMFDUSPOJDTKBNQSFWFOUJPO standby mode and sleep mode.
t 4MFFQ.PEFTIVUTEPXOTISFEEFSBGUFSNJOVUFTPGJOBDUJWJUZ
WHEN IN SLEEP MODE |
|
|
1 | 2 | 3 |
| or |
|
In sleep mode | 5PHFUPVUPGTMFFQNPEFTFUUP | Insert paper |
| OFF ( ), then Auto On ( ) |
|
PRODUCT MAINTENANCE
OILING SHREDDER
"MMDSPTTDVUTISFEEFSTSFRVJSFPJMGPSQFBLQFSGPSNBODF*GOPUPJMFEB
machine may experience diminished sheet capacity, intrusive noise when
TISFEEJOHBOEDPVMEVMUJNBUFMZTUPQSVOOJOH5PBWPJEUIFTFQSPCMFNTXF
recommend you oil your shredder each time you empty your waste bin.FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE |
| |
1 | 2 | 3 |
Set to Off ( ) | *Apply oil across entry | Press and hold Reverse | |
|
| ( | ) |
*Only use a
CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare occasions, the sensors may become blocked by paper dust causing the motor to run even if there is no paper present. (Note: two paper detection sensors are located in the center of the paper entry).
TO CLEAN THE SENSORS |
|
|
|
1 | 2 | 3 | 4 |
5VSOPGG( ) and | Locate | Dip cotton swab in | Using cotton swab, wipe |
unplug shredder | infrared sensor | rubbing alcohol | away any contamination |
|
|
| from the paper sensors |
Go to Support Section at www.fellowes.com or see back page of manual for useful telephone numbers.
TROUBLESHOOTING
0WFSIFBU*OEJDBUPS8IFOUIF0WFSIFBU*OEJDBUPSJTJMMVNJOBUFEUIFTISFEEFSIBTFYDFFEFEJUTNBYJNVNPQFSBUJOHUFNQFSBUVSFBOEOFFETUPDPPMEPXO5IJT indicator will remain illuminated and the shredder will not operate for the duration of the recovery time. See Basic Shredding Operation for more information about the continuous operation and recovery time for this shredder.
#JO0QFO5IFTISFEEFSXJMMOPUSVOJGUIFCJOJTPQFO8IFOJMMVNJOBUFEDMPTFUIFCJOUPSFTVNFTISFEEJOH
Remove Paper: When illuminated, press reverse ( BOESFNPWFQBQFS3FEVDFQBQFSRVBOUJUZUPBOBDDFQUBCMFBNPVOUBOESFGFFEJOUPQBQFSFOUSZ
SafeSense® Indicator: If hands are too close to the paper entry, the SafeSense® indicator will illuminate and the shredder will stop shredding. If SafeSense® is active for 3 seconds, the shredder will automatically turn off and the user must set the switch to OFF (), then Auto On ( ) to resume shredding.
3