Horizontal Placement

To place horizontally on a tabletop or shelf:

1.Attach two rubber hook-shaped stick-on feet symmetrically along the bottom edge of the speaker approximately 18" apart. If you are mounting the speaker on an uneven surface you may need to attach the feet closer to the center. Adapt the actual position to your needs. You may orient the speaker so that the terminals are at either end.

2.Slide the rear support into the channel on the rear of the speaker until it is in the approximate center of the speaker. Orient it so the foot is along the same side as the rubber feet you installed in step 1.

3.Tighten the set-screw finger-tight to stabilize the support.

4.Remove the logo by pulling it straight out. Turn it 90 degrees so that the text reads correctly. Press it back in place.

3. 2.