JVC RM-RXUV9RMD manual Reinforcing the Bass Sound AHB PRO, Tone Control BASS/TREBLE, Bass Control

Reinforcing the Bass Sound (AHB PRO)

You can reinforce the bass sound to maintain rich, full bass at low volume (you can use this effect only for playback):

To get the effect, press the AHB (Active Hyper Bass) PRO but- ton.

The “BASS” indicator lights up on the display. To cancel the effect, press the button again. The “BASS” indicator goes out.

Tone Control (BASS/TREBLE)

You can control the tone by changing the bass and treble. The analog clock acts to display the bass and treble settings.

By pressing either the BASS or TREBLE button on the Remote Control, you can visually see the current tone control settings.

Examples:
		FLAT			Fully boosted
(	)	(	)	(	)	(	)

BASS Control ———————————

You can adjust the bass level (low frequency range level) between –6 and +6. (0: Flat)

■1. Press the BASS button on the Remote Con- trol.

■2. Press the UP or DOWN button on the

Remote Control to adjust the bass level.

BASS

DOWN UP

TREBLE Control ——————————

You can adjust the treble level (high frequency range level) between –6 and +6. (0: Flat)

■1. Press the TREBLE button on the Remote

Control.

■2. Press the UP or DOWN button on the

Remote Control to adjust the treble level.

TREBLE

DOWN UP

Showing the Time (DISPLAY)	English
In Standby mode, the digital clock and analog clock appear on the
display at the same time. Meanwhile, only the analog clock is dis-
played when a music source is selected. Namely, you can see the an-
alog clock at all times.
When the System is turned on, you can display the digital clock at any
time.
Using the CLOCK button on the Unit:
Each time you press the button, the display changes between the nor-
mal display and the digital clock.
Using the DISPLAY button on the Remote Control:
By pressing the button repeatedly, the clock will be displayed.
Example:
Normal display = Remaining time (recordable capacity) of MD =
Clock = (back to the beginning)

Minute Hand

Second Hand

Hour Hand

Note: To let the clock work, you need to set the clock beforehand. (See “Setting the Clock” on page 24.)

7