Azi. adj. knob (X2)
Latitude dial
Latitude
Azimuth lockLatitudeclutch
Adj. Screw
Figure 13. Azimuth adjustment | Figure 14. Latitude Adjustment |
Adjust Polar Scope Focuser
If the polar scope does not focus on the distant object, take the polar scope out of the mount housing. Point the polar scope to a far distant object. Adjust the Objective Lens by turning the tube to get a clear image. Tune the lock ring to secure it.
Replace the Polar Scope back to the mount and tighten it. Adjust the Eyepiece to get a clear picture of the reticle.
Polar Scope Alignment:
Reticle Adj.
Screws
Eyepiece
Objective Lens
Locking Ring
If you are suspecting that the polar scope may be misaligned to the mount R.A. axis, you may check it by putting a star in the center of the polar scope reticle cross hairs and rotating mount’s R.A. axis. If the star stays in the center of cross hairs, the polar scope is aligned to the mount’s R.A. axis.
In the event the polar scope optical axis needs to be adjusted, you can do this procedure at night while pointing at Polaris. However, it is probably easier to do it during the daytime using a distant point, such as a flag pole or top of a building a couple of hundreds away, as your target. Please remove the telescope, the counterweights and counterweight shaft from the mount. Aim the mount to the object. Use the Latitude Adjustment Screw and Azimuth Adjustment Knob to center the object.
7