AT&T TL 7610 user manual Adjust the lifter audio, Headset base installation

Getting started

Headset base installation

Adjust the lifter audio

1.Press MODE on the headset base to change the mode if the LIFTER MODE

light is not on. Make sure that the LIFTER MODE light on the headset base is on.

2. Lift the corded handset from the telephone cradle.

3. After you install and charge the battery

MODE

(see pages 8-10), put the headset next to LIFTER MODE light your ear.

4. Press ON/OFF on the headset to listen for a dial tone.

ON/OFF

5.If there is no dial tone or the dial tone is not clear, slide the LIFTER AUDIO ADJUST switch on the side of the headset base from A to G until the dial tone is clear.

6.If the dial tone is not clear, repeat step 5 until you find the clearest dial tone.

LIFTER AUDIO ADJUST

17