AT&T TL 7610 user manual Battery installation

Getting started

Battery installation

Install the battery as shown below. After installing the battery, you may be able to make and receive short calls. For optimal performance, charge the headset battery for at least 6 hours before use. When the headset is not in use, recharge the headset by returning it to the headset base.

1.If the battery compartment cover is attached, press on both sides of the cover and lift it up and off.

2.Insert the battery into the battery compartment with the label THIS SIDE UP facing up.

3.Push the battery plug into the connector inside the compartment according to the color-coded label Place the wires neatly inside

the compartment.

1

2

3

4. Insert the tab on the bottom of the	4
battery compartment cover into the
battery compartment.

5. Press down gently on the battery compartment cover until it snaps into place.

NOTE: Remove the ear hook from the headset (see page 24) before battery replacement.