AT&T TL 7610 user manual Adding and registering a headset to an AT&T DECT cordless telephone

Getting started

Adding and registering a headset to an AT&T DECT cordless telephone

To register a headset to an AT&T DECT cordless telephone base

1. You must deregister the headset from the headset base (see page 21).

2.Make sure the battery is properly installed in the headset (see page 8). The ON/OFF light

flashes twice every five seconds to indicate the headset is not registered.

3. Place the headset in the headset base and allow it to charge for at least five minutes before beginning the registration. Leave the headset in the headset base while registering the headset.

4. On the telephone base of the cordless phone, press and hold the

HANDSET LOCATOR button until the IN USE light turns on (about four seconds) and then release the button.

5. The headset is registered to the telephone base automatically. It may take about 30 seconds to complete. The IN USE light on the telephone base turns off. The headset ON/OFF light turns blue on the first headset registered and orange on the second headset registered. To verify the registration was successful, press the ON/OFF button and check for a dial tone.

NOTE: If the registration fails, the ON/OFF light on the headset flashes twice every five seconds. Reset the headset and try again. Remove the headset from the headset base and press ON/OFF. Then place the headset back into the headset base. Try the registration process again.

20