AT&T TL 7610 user manual Adding and registering a headset to the headset base

Getting started

Adding and registering a headset to the headset base

To register a headset to the headset base

1.Make sure the battery is properly installed in the headset (see page 8). The ON/OFF light flashes

twice every five seconds to indicate the headset is not registered.

2.Place the headset in the headset base and allow it to charge for at least five minutes before the registration.

3.Remove the headset from the headset base.

4.Press and hold the PAIR button until the MUTE light on the headset base turns on (about four seconds) and release the button.

5.Return the headset to the headset base for registration.

It may take about 30 seconds to complete the registration. The MUTE light on the headset base turns off. The headset ON/OFF light turns blue on the first headset registered and orange

on the second headset registered.

To verify the registration was successful, press the headset ON/OFF button and check for a

dial tone.

If the registration fails, the ON/OFF light

on the headset flashes twice every five seconds. To reset the headset, remove the headset from the headset base and try the registration process again.

19