AT&T TL 7610 Option 1 Headset base with corded or cordless phone installation, POWER jack

Getting started

Headset base installation

Option 1: Headset base with corded or cordless phone installation

To use this installation option, make sure the headset base mode is set to NO LIFTER MODE.

• Plug the small end	• Plug one end of the telephone
of the headset		line cord into the TEL WALL
base power		JACK (red dot) at the back of
adapter into the		the headset base.
POWER jack
(green dot) at
the back of the
headset base.
			• Plug the other end of
	Telephone				the telephone line cord
					into the line splitter.
	line cord
				• Plug the line splitter
					into the telephone wall
					jack (or DSL filter if
	Line splitter				you subscribe to DSL
					Internet service).
• Plug the headset
base power adapter
into an electrical
outlet not controlled
			A DSL filter
by a wall switch.
			(not included) is
			required if you have
			DSL high-speed
			Internet service.
			The DSL filter must
			be plugged into the
			telephone wall jack.
Cordless or corded
phone	•		Connect another

telephone line cord between the telephone and the line splitter.

14