Setup

1.Open the battery cover located on the bottom of the Viewer by sliding it the direction of the arrow on the cover, and insert two AA size batteries (alkaline, lithium or NiMh) with the flat end (negative, or “-” terminal) of each battery in contact with the springs. Slide the cover back to the closed position. The small holes on the back of the Viewer, just below the battery cover, allow sound from the speaker to be heard during playback of video clips that may also contain audio.

2.Slide open the door on the left side of the Viewer in the direction of the arrow on the door. Insert an SD or CF card* into the correct size slot (do not attempt to insert an SD card into the CF card slot). With the slots oriented as shown in the Parts Guide, (lettering upright, USB on right), SD cards should be inserted “face down” (metal contacts on card facing up, notched corner on rear left). To insert, push the SD card in until a click is heard. To remove, push in again, then pull out. CF cards simply push in/pull out (face up). Use the “Camera” slots (A) for cards from your Trail Camera. Use the “Storage” slot (B) for a blank SD card (optional) if you will want to copy photos from a card in one of the “Camera” slots. After inserting your card(s), briefly press the Power switch on the lower right side of the Viewer. The screen will activate in a few seconds (the time it takes may vary with the number and size of the files on your card) and display the first image on your camera card. To turn off the Viewer when you are done, press the Power button again. Replace the door (cards may be left in place) that covers the slots and USB port when not using or carrying your Viewer, to prevent the entry of dust and dirt.

3.Please refer to the section titled “Setup Options” for details on how to change the language used for all display menus and change the Auto Off interval if desired.

*Secure Digital or Compact Flash