Bushnell 119537C, 119547C, 119576C, 119577C Scan a Stop & Start, Steps 4 & 5 are Optional only

7:00 PM. No Field Scan recording would occur from 8AM to 5:30PM, or from 7PM to 6AM. Remember, Field Scan recording is independent of normal triggers due to animal activity–even if no animals enter the IR sensor coverage zone, an image or video will still be captured every 15 minutes during the block(s) of time. If an animal triggers the camera “in between” the 15 minute intervals, it will be recorded, same as it would if you had setup the camera with Field Scan turned Off. Note: Field Scan settings of frequent intervals and/or long periods between start and stop time can reduce battery life.

(Step 1)-set Field		(Step 2)-select Field	(Step 3)-set Field
Scan Mode to “On”		Scan "A" (press OK)	Scan "A" Stop & Start
Steps 4 & 5 are
optional (only
required if you want
to set up a second
block of Field Scan
recording with	(Step 4) (opt)-select Field (Step 5) (opt)-set Field
different stop and
		Scan "B" (press OK)	Scan "B" Stop & Start
start times)

Note: the Interval Setting sets the timing between each image for both Field Scan "A" and "B" recording blocks.

(Step 6)-select Field	(Step 7)-set Field
Scan "Interval"	Scan Interval

16