Stamina Products E100 owner manual Metal Fitting Cable End

Page 8

ASSEMBLY INSTRUCTIONS

Metal Fitting

 

Cable End

Strap

 

Bracket

 

Spring Hook

 

 

Strap

STEP 6: Refer to the inset drawing. Lay the UPRIGHT(6) on the floor close to the front of the MAIN FRAME(1). Turn the TENSION KNOB(21) on the UPRIGHT(6) counterclockwise as far as it can go, so the cable end extends out of the metal fitting as far as possible. Connect the CABLE END of the TENSION KNOB(21) into the SPRING HOOK on the end of the TENSION CABLE(20). Pull the CABLE on the TENSION KNOB(21) firmly and insert the cable through the slot in the bracket. Then insert the METAL FITTING on the end of the CABLE of the TENSION KNOB(21) into the hole at the end of the slot in the BRACKET. Adjust the TENSION KNOB(21) and verify that the SPRING HOOK moves when the TENSION KNOB(21) is adjusted.

STEP 7: There is a strap attached inside of the UPRIGHT(6). This strap is to assist in pulling the SENSOR WIRE(23) through the UPRIGHT(6).

Tie the strap to the plug end of the SENSOR WIRE(23). Pull the strap from the top of the UPRIGHT(6) until the SENSOR WIRE(23) is pulled through the UPRIGHT(6) as shown in the above illustration. The SENSOR WIRE(23) must extend out the top of the UPRIGHT(6).

STEP 8

NOTE: 1. Make sure the NYLOCK NUTS(M8x1.25)(62) fit into the hex holes on the top of the MAIN FRAME(1) before tightening the BUTTON HEAD BOLTS(M8x1.25x57mm)(49).

2. Be careful not to damage the SENSOR WIRE(23) when assembling the UPRIGHT(6).

Insert the UPRIGHT(6) into the MAIN FRAME(1) and secure with BUTTON HEAD BOLTS (M8x1.25x57mm)(49), ARC WASHERS(M8)(66), and NYLOCK NUTS(M8x1.25)(62).

8

Image 8
Contents Owners Manual Table of Contents Safety InstructionsCall US First Before YOU Begin SpaceMate E100Hardware Identification Chart Assembly Instructions BackARM5 Metal Fitting Cable End Assembly Instructions SET UP Instructions Function InspectionOperational Instructions Using the Electronic Meter Function ButtonOperational Instructions Load Adjustment Exercise WorkoutMaintenance StorageConditioning Guidelines Target Heart Rate Zone Estimated by AgeWARM-UP and COOL-DOWN Product Parts Drawing DIAGRAM# Part Name QTYDIAGRAM# Part Name Warranty Page Page FAX/MAIL Ordering Form Stamina Products, Inc Box Springfield, MO