JVC CA-MXGT88, CA-MXGA77 manual Common Operations, Turning On or Off the Power, Setting the Clock

Common Operations

Turning On or Off the Power

2 Turn the 4/¢control to adjust the hour, then press SET.

To turn on the unit, press so that the

STANDBY lamp goes off.

To turn off the unit (on standby), press again so that the STANDBY lamp lights up.

A little power is always consumed even while the unit is on standby.

To switch off the power supply completely,

power cord from the AC outlet.

STANDBY

ECO

STANDBY

ECO

unplug the AC

SET

The minute digits start flashing on the display.

•If you want to correct the hour after pressing SET, press CANCEL/DEMO. The hour digits start flashing again.

3 Turn the 4/¢control to adjust the minute, then press SET.

When you unplug the AC power cord or if a power failure occurs

The clock is reset to “– – : – –” soon, while the tuner preset stations (see page 12) will be erased in a few days.

SET

Saving the Power Consumption While on Standby—ECO Mode

You can save the power consumption while the unit is turned off (on standby).

To activate the ECO mode, press ECO	STANDBY
	ECO
while the unit is turned off (on standby).
The display illumination (including the
display demonstration) disappears.

To deactivate the ECO mode, press ECO again. The display illumination appears.

• Turning on the unit also deactivates the ECO mode.

About the ECO mode

While the ECO mode is activated, the display demonstration is canceled temporarily.

Setting the Clock

Before operating the unit any further, first set the clock built in this unit. You can set the clock whether the unit is on or off.

On the unit ONLY:
1 Press CLOCK/TIMER.
	/ TIMER
	CLOCK

The hour digits start flashing on the display.

To check the clock time

Press DISPLAY while playing any source. DISPLAY

•Each time you press the button, the source indication and the clock time alternate on the display.

To adjust the clock again

If you have adjusted the clock before, you need to press CLOCK/TIMER repeatedly until “CLOCK” is selected.

•Each time you press the button, the clock/timer setting modes change as follows:

DAILY ON TIME REC

(Daily Timer)

Canceled CLOCK ON TIME

(Recording Timer)

If there is a power failure

The clock loses the setting and is reset to “– – : – –.” You need to set the clock again.

Selecting the Sources

To listen to the radio, press FM/AM. (See page 12.) To play back CDs, press CD 6. (See pages 15 – 21.) To play back tapes, press TAPE 3. (See page 22.)

To select the external equipment as the source, press AUX.

When you press the play button for a particular source (AUX, FM/AM, CD 6, and TAPE 3), the unit turns on (and the unit starts playing the source if it is ready—COMPU PLAY CONTROL).

9