black
UPRIGHT POST
Connect the upper and lower meter wires together and push the tension cable into the upright post prior to fitting the upright post to the main frame. Secure the upright post to the main frame with four chromed washers and Allen screws. Ensure that the concave side of the washer faces the handlebar support tube. First turn all the screws loosely into place and then tighten them.
chrome
RESISTANCE KNOB
Make sure the display window shows 8 on the knob. Remove the attachment screw and pull out the resistance knob from upright post. Pull the end of the resistance wire out from the handlebar support tube and connect the resistance wire to the lower end of the brake wire. Make sure the resistance wire is tightly inserted. Push the wire inside the handlebar support tube, place the resistance knob over the hole in the tube and attach it with the screw.
E340
O W N E R ' S M A N U A L • F 3 3 0 • E 3 4 0
8
METER
Pop open the battery cover at the back of the meter to assemble batteries. Close the cover. Remove the cable ties from the wires of the handlebar support. Connect the wires to the respective connectors
on the meter and then thread the wires into the handlebar. Be careful not to damage the wires when attaching the interface. Slide the meter on the top of the handlebar support tube and attach it with three locking screws through the plastic sleeve.
E340
SEAT
Attach the seat to the seat support: tighten the locking nuts in opposite directions. Please note that you can adjust both seat inclination and the distance of the seat from the handlebar. Once the distance and inclination are set how you want, tighten the locking nuts carefully.
G B
3