JVC CA-MXGT80, CA-MXG70 manual Using the Microphones, Sining along Karaoke

Page 26
Turn MIC LEVEL to MIN.

English

Using the Microphones

You can enjoy singing along (Karaoke) and microphone mixing by using two microphones.

MIC LEVEL adjustment is valid for both microphones connected MIC 1 and MIC 2 jacks.

IMPORTANT:

Always set MIC LEVEL to MIN when connecting or disconnecting the microphone.

When you do not use the microphone, keep the microphones unconnected.

Sining along — Karaoke

Vocal Masking

Vocal Masking reduces the lead vocal of the playing source, and allows you to replace it by singing into the microphones as the music plays.

If howling or squealing (feedback) occurs while using the microphone(s)

Take the following actions to prevent these noises.

Adjust MIC LEVEL and VOLUME.

Avoid pointing the microphone(s) towards the speakers.

When two microphones are connected, turn off the ON/OFF switch on the unused microphone.

If you use the following sources as the playing source for Karaoke (Vocal Masking), you cannot get the satisfactory results

Radio programs — a radio signal is not as reliable as the signals coming from a tape or CD.

Monaural sources.

Poorly dubbed tapes.

Sources recorded with duets, strong echo, a chorus, or only a few instruments.

1

2 Connect the microphone(s) (not supplied) by plugging it into MIC 1 and/or MIC 2 jack.

3 Press KARAOKE on the remote control.

The karaoke ( ) indicator lights up on the display.

4 Start playing the source — CD, tape, or other connected component.

5 Turn MIC LEVEL and VOLUME as you sing into the microphone(s).

• By pressing REC START/STOP, you can record your singing along if you want. (For more details, see page 18.)

To apply an echo to your voice

Press ECHO on the remote control so that the echo () indicator lights up on the display.

Each time you press the button, the echo level changes as follows:

ECHO 1 ECHO 2 ECHO 3

ECHO OFF (Canceled)

As the number increases, a stronger echo effect applies to your voice.

Microphone mixing

When you sing along with multiplex tapes or CDs, follow the procedure below:

1 Connect the microphone(s).

2 Start playing the source — CD, tape, or other connected component.

3 Turn MIC LEVEL and VOLUME as you sing into the microphone(s).

• By pressing REC START/STOP, you can record your singing along if you want. (For more details, see page 18.)

To use microphone only

Without any background sound, you can use your microphone(s), and record it if you want.

1 Connect the microphone(s).

2 Press CD 3/8, then 7.

No background sound will be heard.

3 Turn MIC LEVEL and VOLUME as you sing into the microphone(s).

• By pressing REC START/STOP, you can record your singing along if you want. (For more details, see page 18.)

– 21 –

Image 26 Contents
CA-MXGT90/CA-MXGT80 CA-MXG70 Page English Español Português CA-MXGT90 CA-MXGT80 CA-MXG70 Class Laser Product About This Manual PrecautionsIntroduction Contents Front Panel Location of the Buttons and ControlsFront Panel Become familiar with the buttons and controls on your unitFM/AM button and lamp 9 Display WindowSee pages in the parentheses for details AUX button and lampRemote Control Remote ControlGetting Started Supplied AccessoriesConnecting Antennas FM antennaClose the speaker terminals Connecting SpeakersTurn the AM loop antenna until you have the best reception AM antennaCanceling the Display Demonstration Connecting Other EquipmentAdjusting the Voltage Selector On the unit onlyCommon Operations Turning On or Off the PowerSetting the AM Tuner Interval Spacing Setting the Clock Selecting the SourcesReinforcing the Bass Sound Adjusting the VolumeTo turn down the volume level temporarily Selecting the Sound ModesTo use your own sound mode Creating Your Own Sound Mode Manual ModeOn the unit only Select one of the preset sound modes Tuning in a Preset Station Tuning in a StationPresetting Stations Listening to FM and AM BroadcastsPress the same 0 you have pressed in step Playing Back CDs CD/CD-R/CD-RWLoading CDs Repeat steps 1 to 3 to place other CDsPlaying Back the Entire Discs Continuous Play Basic CD OperationsProgram Play Prohibiting Disc Ejection Tray Lock Random indicator also lights up onRandom play also stops when one of the disc trays is opened To exit from Random play mode, press Random againLocating the Beginning of a Song Music Scan Playing Back TapesPlaying Back a Tape Press Eject 0for the deck B RecordingRecording a Tape on Deck B To protect your recordingCD Direct Recording To record on both sides Reverse ModeDubbing Tapes Press DubbingAuto Edit Recording Connect the microphones Press CD 3/8, then Using the MicrophonesSining along Karaoke Press CLOCK/TIMER again Using the TimersUsing Daily Timer How Daily Timer actually worksWhen selecting CD If you have set the Daily Timer With the unit turned onWhen selecting Tuner FM or Tuner AM Turn 4/ ¢to set the volume levelHow Recording Timer actually works Using Recording TimerSelect the preset station Unit enters preset station selecting modeOn the remote control only Press Sleep Using Sleep TimerTimer Priority Wait for about 5 seconds after specifying the time lengthTo clean the disc MaintenanceCleaning the unit Handling discsTroubleshooting SymptomSpecifications CA-MXGT80 CA-MXG70 Seletor de voltagem a fim de evitar avarias ou riscos de Posição do seletor de voltagem localizado na parte externaDeste equipamento. Caso não corresponda, reajuste o Incêndio e choque elétricoPage Page