JVC CA-UXP6R, CA-UXP4R Program Play, On the remote control only Load a CD, Press Prog program

Programming the Playing Order of the Tracks

— Program Play

You can arrange the order in which tracks play before you start playing. You can program up to 20 tracks.

To check the program contents

You can check the program contents by pressing PROG on the remote control. The programed tracks are shown in the programed order.

PROG

On the remote control ONLY:

1 Load a CD.

•If the current playing source is not the CD player, press CD 3/8, then 7 before going to the next step.

2 Press PROG (program). PROG

The PRGM (program) indicator lights up on the display.

PRGM

•If a program has been stored in memory, the program is called up.

3 Press MULTI KEY > or MULTI KEY < to select the track number, then press SET.

MULTI KEY SET

		PRGM
		Track number Program step number
4	Repeat step 3 to program other tracks you
5	want.
	Press CD 3/8.		CD

The tracks are played in the order you have programed.

To stop playing, press 7.

To exit from Program play mode, press 7before or after playing. The PRGM (program) indicator goes off. All the programed tracks will be cleared.

• Disc ejection also erases the program.

To modify the program

Before or after playing, you can erase the last	CANCEL
programed track by pressing CANCEL on the
remote control.

•Each time you press the button, the last programed track is erased from the program.

To add tracks in the program before playing, simply select the track numbers you want to add by following step 3 of the programming procedure.

•If you try to program the 21st track “FULL” will appear on the display.

•If the total playing time is 100 minutes or more

The total playing time will not be shown. “– –:– –” will appear.

– 15 –