Life Fitness X7 manual Assemble the Rocker Arms Moving Arm Pivot Covers

Step 5 Assemble the Rocker Arms; Moving Arm Pivot Covers

Parts: Hardware Bag #3 (2, Wave Washers, 2 Large Flat Washers) (2, Flat Washers)

(2, 20mm Long Hex Head Bolts)

(4, 8mm Long Black Phillips Head Screws)

Tools: 17mm Socket Wrench, Phillips Screwdriver

Slide one large flat washer (4) and one wave washer (5) onto the user right pivot shaft (F). Slide the washers fully over the pivot shaft until seated against the pre-installed stop ring (G).

Locate the user right rocker arm assembly (H) marked with a R. With the top handgrip facing the front of the units slide the right rocker arm assembly onto the user right pivot shaft until seated against the washers.

Secure the rocker arm assembly to the pivot shaft using one flat washer (6) and one 20mm long hex head bolt (7). Tighten the bolt securely. Repeat the procedure for the left rocker arm assembly.

Attach the right side upper pivot covers (J) labeled with the letter "R" over the upright shaft. Snap the covers together and use two 8mm long black Phillips head screws (8) to attach the covers. Repeat for left side.

CAUTION: There is a different left and right cover.

14