English
Common Operations
Setting the Clock
Before operating the unit any further, first set the clock built in this unit.
1 | Press PANEL OPEN/CLOSE. | PANEL |
OPEN / CLOSE | ||
| ||
| The unit is turned on and the Powered Rolling |
|
| Panel opens automatically. |
|
2 | Press TIMER/CLOCK. | /CLOCK |
|
| TIMER |
The hour digits start flashing on the display.
PRESET
3 Press 4or ¢to adjust the hour, then press SET.
SEA CONTROL
SET
•If you want to correct the hour after pressing SET, press CANCEL. The hour digits start flashing again.
PRESET
4 Press 4or ¢to adjust the
Turning On the Power and Selecting the Sources
When you press the play button for a particular source (FM/ AM, CD 6, AUX, and TAPE 23), the unit turns on, and the Powered Rolling Panel opens automatically (and the unit starts playing the source if it is ready — COMPU PLAY CONTROL).
To listen to the FM/AM (MW/LW) broadcasts, press FM/
AM. (See pages 12 – 14.)
To play back CDs, press CD 6. (See pages 15 – 17.) To play back tapes, press TAPE 23. (See page 18.)
To select the external equipment as the source, press AUX.
FM/ AM | C D | TAPE | AUX |
|
|
|
STANDBY
To turn on the unit without playing, press 
so that the STANDBY lamp goes off.
The Powered Rolling Panel opens automatically.
minute, then press SET.
To turn off the unit (on standby), press 
again so that the STANDBY lamp lights up. The Powered Rolling Panel also closes.
STANDBY
SEA CONTROL
A little power is always consumed even while the unit is on standby.
To check the clock time
Press DISPLAY while playing any source.
SET
DISPLAY
To switch off the power supply completely, unplug the AC
power cord from the AC outlet.
• Each time you press the button, the source indication and the clock time alternate on the display.
To adjust the clock again
If you have adjusted the clock before, you need to press TIMER/CLOCK repeatedly until the clock setting mode is selected.
•Each time you press the button, the timer/clock setting modes change as follows:
DAILY 
ON TIME 
REC
Canceled
Clock
ON TIME
setting
(The hour digits start flashing.)
If there is a power failure
The clock loses the setting and is reset to “0:00.” You need to set the clock again.
When you unplug the AC power cord or if a power failure occurs
The clock is reset to “0:00” right away, while the tuner preset stations (see page 12) will be erased in a few days.
– 9 –