INTRODUCTION
A S S E M B LY STEP 2
A S S E M B LY STEP 4
INTRODUCTION
IMPORTANT PRECAUTIONS
ASSEMBLY
HARDWARE BAG FOR STEP 2 CONTENTS :
�������������������� | �������� |
����� | |
������ | ������ |
����������
���������������
��������
A)Open HARDWARE BAG FOR STEP 2.
B)Slide left and right FOOT LEVELERS onto MAIN FRAME.
C)Attach FOOT LEVELERS using WASHER (E) and BOLT (F).
|
| ��������������� |
| ����� |
|
|
| ������������ |
������������ | ��� | ���������� |
|
������������
�������������
�����
���������
NOTE: There is NO hardware for steps
A) Remove |
WASHERS from CONSOLE MAST. |
B) Slide LOWER HANDLEBAR onto |
CONSOLE MAST and attach by re- |
inserting |
WASHER. |
C) Slide UPPER HANDLEBAR onto |
LOWER HANDLEBAR and align |
NOTCH with TAB making sure |
handlebars are joined together |
completely. Secure UPPER |
IMPORTANT PRECAUTIONS
ASSEMBLY
BEFORE YOU BEGIN
ELLIPTICAL OPERATION
������������
A S S E M B LY STEP 3
HARDWARE BAG FOR STEP 3 CONTENTS :
| ����� | |
����������������������� | ������� | |
������ | ||
���������� | ||
| ||
����������������������� | ��������� | |
����� | ����� | |
������ | ������ |
HANDLEBAR to LOWER HANDLEBAR |
using |
D) Repeat on other side. |
WARNING | After handlebars are assembled they will rotate freely – be cautious. Until the |
machine is fully assembled, do not grab the handlebars for support. |
HARDWARE BAG FOR STEP 4 CONTENTS : | 4.2E ONLY |
��������� | �������� |
����� | ����� |
������ | ������ |
BEFORE YOU BEGIN
ELLIPTICAL OPERATION
CONDITIONING TROUBLESHOOTING LIMITED
GUIDELINES & MAINTENANCE WARRANTY
8
����������
�������������
�����������������
���������
������������
���������� ���������������
���������
A)Open HARDWARE BAG FOR STEP 3.
B)Slide TEFLON SHEET WASHER (G), PEDAL ARM and TEFLON WASHER
(H)over PEDAL ARM BRACKET
C)Secure PEDAL ARM to PIVOT TUBE, using NYLON NUT (I).
D)Attach PEDAL ARM COVER using SCREW (J).
E)Repeat on other side.
4.2E ONLY
��������� 
���������
���������
���������
������
4 . 2E only
E)Open HARDWARE BAG FOR STEP 4.
F)Attach FRONT & BACK HANDLEBAR COVERS using 2 SCREWS (K) and 2 BOLTS (L) for each side.
9
LIMITED TROUBLESHOOTING CONDITIONING WARRANTY & MAINTENANCE GUIDELINES
Elite 3.2E 4.2E Elliptical Rev 1.0.indd | 7/13/05 2:47:56 PM |