2E Assembly, Pedal ARM | Horizon Fitness 1.2E, 2.2E manual

INTRODUCTION

1.2E ASSEMBLY

ASSEMBLY STEP 3

ASSEMBLY STEP 4

INTRODUCTION

IMPORTANT PRECAUTIONS

ASSEMBLY

BEFORE YOU BEGIN

��

HARDWARE BAG FOR STEP 3 CONTENTS :

��

��	��
��	��
��	��

��

NOTE: There is NO hardware bag for this step. Hardware is pre-installed.

A)Remove PRE-ATTACHED BOLT & WASHERS from CONSOLE MAST.

B)Slide UPPER HANDLEBARS onto CONSOLE MAST and attach by re-inserting PRE-ATTACHED BOLT & WASHERS.

IMPORTANT PRECAUTIONS

ASSEMBLY

BEFORE YOU BEGIN

A) Open HARDWARE BAG FOR STEP 3.

B) Slide the CONSOLE MAST BOOT over the bottom of the CONSOLE MAST.

ASSEMBLY STEP 5

ELLIPTICAL CONDITIONING OPERATION GUIDELINES

C) Carefully pull console wires through the CONSOLE MAST. Attach the CONSOLE WIRES to the pre-attached

routing wire. Discard wire when finished.

D) Slide CONSOLE MAST into MAIN FRAME.

E) Insert 3 BOLTS (C), 3 LOCK WASHERS (D) and 3 ARC WASHERS (E) into back of CONSOLE MAST.

F) Attach CONSOLE MAST to MAIN FRAME using BOLT (B) and NUT (F).

G) Slide CONSOLE MAST BOOT down to cover exposed bolts.

��

A) Open HARDWARE BAG FOR STEP 5.

B) Place TEFLON COATED WASHER

(H) over CRANK ARM followed by

PEDAL ARM.

C) Place a second TEFLON COATED

WASHER (H) over PEDAL ARM and

attach using NUT (G).

D) Repeat on other side.

CONDITIONING ELLIPTICAL GUIDELINES OPERATION

��

E) Attach PEDAL ARM COVERS to

��

PEDAL ARMS using SCREWS (I).

TROUBLESHOOTING LIMITED

MAINTENANCE WARRANTY

HARDWARE BAG FOR STEP 5 CONTENTS :

	��	��
��	��
��		��
	��
		��
��	��

LIMITED TROUBLESHOOTING WARRANTY & MAINTENANCE

Elite 1.2E 2.2E Rev.1.0.indd 8-9

7/19/05 8:20:13 AM