INTRODUCTION
2.2E ASSEMBLY
A S S E M B LY STEP 6
ASSEMBLY STEP 7
INTRODUCTION
IMPORTANT PRECAUTIONS
ASSEMBLY
BEFORE YOU BEGIN
������������������������ | �������� |
���������
���������������
���������� 
���������
A) Open HARDWARE BAG FOR STEP 6. |
B) Attach FOOTPAD to FOOT PLATE using 4 BOLTS (K). |
�������
��������
�������� ��������������� 
���������� 
�����������������
HARDWARE BAG FOR STEP 7 CONTENTS :
A)Open HARDWARE BAG FOR STEP 7.
B)Remove
C)Slide LOWER HANDLEBARS onto CONSOLE MAST and attach by
D)Attach UPPER HANDLEBARS to LOWER HANDLEBARS using PRE-
ATTACHED SCREWS.
D)Attach HANDLEBAR COVERS using 4 SCREWS (J).
IMPORTANT PRECAUTIONS
ASSEMBLY
BEFORE YOU BEGIN
ELLIPTICAL OPERATION
C) Slide WAVY WASHER (L) and the FOOT PLATE onto the PEDAL ARM axle. |
D) Attach FOOTPAD BRACKET to FOOT PLATE using 3 BOLTS (M). |
E) Repeat on other side. |
ASSEMBLY STEP 8
ELLIPTICAL OPERATION
CONDITIONING TROUBLESHOOTING GUIDELINES & MAINTENANCE
HARDWARE BAG FOR STEP 6 CONTENTS :
�������� | �������� |
����� | ���� |
������ | ������ |
���������������
������
����
����������
������
�������
������������� 
������������
������
������������ 
NOTE: There is NO hardware bag for this step. All hardware is pre- installed.
A)Attach the CONSOLE WIRES.
B)Carefully tuck the CONSOLE MAST wires into the CONSOLE MAST before attaching the
CONSOLE.
C)Attach CONSOLE to the CONSOLE MAST using the
4
TROUBLESHOOTING CONDITIONING & MAINTENANCE GUIDELINES
LIMITED
WARRANTY
16
YOU’RE FINISHED! | DO NOT PINCH WIRES! |
|
17
LIMITED WARRANTY
Elite 1.2E 2.2E Rev.1.0.indd | 7/19/05 8:20:41 AM |