Arm, Washers | Horizon Fitness 2.2E, 1.2E specs

INTRODUCTION

2.2E ASSEMBLY

ASSEMBLY STEP 3

ASSEMBLY STEP 4

INTRODUCTION

IMPORTANT PRECAUTIONS

ASSEMBLY

��

HARDWARE BAG FOR STEP 3 CONTENTS :

��	��
��	��
��	��
��	��
��	��
��	��

��

A) Open HARDWARE BAG FOR STEP 4.

B) Place TEFLON WASHER (H) over

CRANK ARM followed by PEDAL

ARM.

C) Place a second TEFLON WASHER

(H) over PEDAL ARM and attach

using NUT (G).

D) Repeat on other side.

IMPORTANT PRECAUTIONS

ASSEMBLY

��

E) Attach PEDAL ARM COVERS to

BEFORE YOU

��

PEDAL ARMS using SCREWS (I).

BEFORE BEGIN

BEGIN

ELLIPTICAL OPERATION

A) Open HARDWARE BAG FOR STEP 3.

B) Slide the CONSOLE MAST BOOT over the bottom of the CONSOLE MAST.

C) Carefully pull console wires through the CONSOLE MAST. Attach the CONSOLE WIRES to the pre-attached

routing wire. Discard wire when finished.

D) Slide CONSOLE MAST into MAIN FRAME.

HARDWARE BAG FOR STEP 4 CONTENTS :

��	��	��
��	��	��
��	��	��

ASSEMBLY STEP 5

YOU

ELLIPTICAL OPERATION

CONDITIONING GUIDELINES

E) Insert 3 BOLTS (C), 3 LOCK WASHERS (D) and 3 ARC WASHERS (E) into back of CONSOLE MAST.

F) Attach CONSOLE MAST to MAIN FRAME using BOLT (B) using NUT (F).

G) Slide CONSOLE MAST BOOT down to cover exposed bolts.

��

��
��	��
	��

A) Open HARDWARE BAG FOR STEP 5.

B) Remove PRE-ATTACHED BOLT &

WASHERS from CONSOLE MAST.

C) Slide LOWER HANDLEBARS onto

CONDITIONING GUIDELINES

TROUBLESHOOTING & MAINTENANCE

��

CONSOLE MAST and attach by

re-inserting PRE-ATTACHED BOLT

& WASHERS.

D) Attach UPPER HANDLEBARS to

LOWER HANDLEBARS using PRE-

TROUBLESHOOTING MAINTENANCE

LIMITED

WARRANTY

HARDWARE BAG FOR STEP 2 CONTENTS :

��

ATTACHED SCREWS.

D)Attach HANDLEBAR COVERS using 4 SCREWS (J).

LIMITED WARRANTY &

Elite 1.2E 2.2E Rev.1.0.indd 14-15

7/19/05 8:20:38 AM