Horizon Fitness 2.2E YOU’RE Finished, Bolt N, Knob Bracket, Bolt & Washer, Do not Pinch Wires

INTRODUCTION

1.2E ASSEMBLY

ASSEMBLY STEP 6

ASSEMBLY STEP 7

INTRODUCTION

IMPORTANT PRECAUTIONS

ASSEMBLY

BEFORE YOU BEGIN

ELLIPTICAL CONDITIONING OPERATION GUIDELINES

������������

����������

���������������

����������

��������������

��������

�����������������

���������������

���������������

���������������

����������

A)Open HARDWARE BAG FOR STEP 6.

B)To attach LOWER LINK ARM to PEDAL ARM, slide SPACER (J), FLAT WASHER (K) and WAVY WASHER (L) onto PEDAL ARM BRACKET.

NOTE: Attaching the lower link arm assembly to the pedal arm first makes assembly of the linkage arms less difficult.

C)Slide LOWER LINK ARM onto PEDAL ARM BRACKET, followed by FLAT WASHER (M) and

BOLT (N).

D)Repeat on other side.

E)Slide LOWER LINK ARM onto UPPER HANDLEBAR and attach using 2 PRE-ATTACHED SET SCREWS.

F)Attach HANDLEBAR COVERS using 2 SCREWS (O).

G)Repeat on other side.

������������� ����������	������������
�����������������

���������������

�������

�����

����������������������

������������

STEPS A-E

NOTE: There is NO hardware bag for this step. All hardware is pre- installed.

A) Pull TENSION CABLE out from

square hole in console mast.

B) Turn RESISTANCE KNOB to highest

resistance setting. Place the

TENSION WIRE into the BOTTOM

KEY HOLE on the RESISTANCE

KNOB BRACKET.

C) While holding the RESISTANCE

KNOB BRACKET, pull the

RESISTANCE KNOB up to slide it

into the TOP KEY HOLE position on

the RESISTANCE KNOB BRACKET.

D) Once the TENSION WIRE is in

position, turn the RESISTANCE

KNOB to the lowest resistance

setting.

E) Slide RESISTANCE KNOB &

BRACKET into the CONSOLE MAST

and attach using PRE-INSTALLED

BOLT & WASHER.

F) Attach the CONSOLE WIRES (2

heart rate wires and 1 speed

sensor wire).

G) Carefully tuck the CONSOLE WIRES

into the CONSOLE MAST before

IMPORTANT PRECAUTIONS

ASSEMBLY

BEFORE YOU BEGIN

CONDITIONING ELLIPTICAL GUIDELINES OPERATION

TROUBLESHOOTING LIMITED & MAINTENANCE WARRANTY

10

HARDWARE BAG FOR STEP 6 CONTENTS :

����������	���������������	����
	�����	����������
����������		�����
	������
������		������
����		���������
����������	��������
	�����	�����
�����
		������
������	������

������������

������

STEPS F-H

attaching the CONSOLE.

H) Attach CONSOLE to the CONSOLE

MAST using the 2 PRE-ATTACHED

SCREWS (screws will have to be

removed from the console first).

DO NOT PINCH WIRES!

YOU’RE FINISHED!

11

LIMITED TROUBLESHOOTING WARRANTY & MAINTENANCE

Elite 1.2E 2.2E Rev.1.0.indd 10-11 7/19/05 8:20:19 AM