Location of Controls Rear View of Main Unit

GETTING STARTED

Location of Controls (Rear View of Main Unit)

29	31
	31
	32
	33

29.AC Power Socket

30.FM antenna

31.Left speaker output

32.Subwoofer output

33.Right speaker output

GETTING STARTED

Antenna Connection

You can achieve acceptable reception if you use the supplied FM pigtail antenna. If so, the antenna should be elongated and not coiled or bunched up. If it hangs freely, it can be quite effective.

Speaker Connection

Insert LEFT speaker’s striped wire into LEFT channel’s speaker block by pressing the RED lever and inserting the striped wire into the open hole. Do the same with the LEFT speaker’s non-striped wire and the BLACK lever. Repeat for the RIGHT channel SPEAKER block and the RIGHT speaker’s wire.

Subwoofer Connection

This unit includes a subwoofer output jack on the rear panel labeled “SUBWOOFER”. You may connect an external, powered subwoofer (included with iMM9500 only) using a single RCA-type cable as shown below.

	(Cable and subwoofer	Subwoofer
	included with	Subwoofer
	included with
	iMM9500 only)

AC Power Connection

Connect the power cable (included in the accessories) first to the power socket at the unit and then insert the power plug into the wall outlet. When you disconnect the plug from a socket, do not pull the cable, always pull the plug.

Note: When the unit is connected to AC power, it is in Standby mode. To switch off the unit completely, remove the plug from the AC outlet.

Once the unit is plugged in, its time display will start flashing. Refer to “Setting the clock” on P. 13, to set the current time

9 iLuv

iMM9400/9500 V10M10_IM_EN_060509

iLuv 10