JVC SP-UXA7DVD, CA-UXA7DVD, UX-A7DVD manual Loading a Disc, On-screen guide icons

IMPORTANT:

Before performing any operations for DVD, SVCD and VCD, make sure of the following:

•Check the connection with the TV.

•Turn on the TV and select the correct input on the TV to view the pictures or on-screen menus/indications on the TV screen.

•Select the correct color system.

To prevent screen burn-out with the screen saver

A TV screen may be burned out if a static picture is displayed for a long time. To prevent this, the unit automatically dims the screen if a static picture is displayed for over 5 minutes (the screen saver function).

•Pressing any button will cancel the screen saver function.

•You can select the screen saver mode. (See page 58.)

•The screen saver does not work for Audio CDs and MP3 discs.

On-screen guide icons

•During DVD playback, the following guide icons may appear for a while on the TV screen:

–“” : appears at the beginning of a scene containing multi-angle views.

–“ ” : appears at the beginning of a scene containing multi-audio languages.

–“ ” : appears at the beginning of a scene containing multi-subtitle languages.

• “ ” (Play), “	” (Pause), “		”/“	” (Fast
forward/backward), “		”/“	” (Slow-motion

forward/backward): appears when you perform each operation.

•If “ ” appears on the TV screen when pressing a button, the disc cannot accept an operation you

have tried to do, or information required for that operation is not recorded on the disc.

More about the on-screen guide icons

•In some cases, without showing “ ,” operations will not be accepted.

•If you do not want the on-screen guide icons to appear, see page 58.

Loading a Disc

Available for: DVD SVCD VCD Audio CD MP3

1 Press DVD 0 on the main unit.

The unit automatically turns on, the electronic swing panel slides downward, then the disc tray comes out.

Disc tray

Electronic swing panel

2 Place a disc correctly on the circle of the disc tray with its label side up.

Good No good

•When using an 8 cm disc, place it on the inner circle of the disc tray.

3 Press DVD 0.

The disc tray closes, then the electronic swing panel slides upward automatically.

•If you press DVD #/8 on the main unit (or DVD SELECT 3 on the remote control) instead of DVD 0, the disc tray and electronic swing panel closes, then playback starts.

To remove the disc, press DVD 0.

•After removing the disc, press DVD 0 again to close the disc tray.

•When you use the Resume function (see page 58), pressing DVD 0 erases the memory of the position where you have stopped playback.

About the disc indicators

When a DVD	When a SVCD or	When an Audio CD
is loaded.	VCD is loaded.	or MP3 disc is
		loaded.

•The disc indicator rotates while a disc is being played.

•The disc indicator goes off when there is no disc in the disc tray.

28