Precor p20 manual Important Safety Instructions

Page 7

Important Safety Instructions

5

Proper Location for Equipment

For all equipment other than treadmills: Locate at least 40 inches (1 meter) away from walls or furniture on either side of the equipment, and 40 inches (1 meter) away from objects behind the equipment.

For treadmills: Locate at least 40 inches (1 meter) away from walls or furniture on either side of the treadmill, and at least 80 inches (2 meters) away from objects behind the treadmill.

Important: These location standards should also be used when positioning equipment away from sources of heat, such as radiators, heat registers, and stoves. Avoid temperature extremes.

Keep equipment away from water and moisture. Avoid dropping anything on or spilling anything inside the equipment to prevent electric shock or damage to the electronics.

When using the treadmill, always attach the safety clip to your clothing before beginning your workout. Failure to use the safety clip may pose a greater risk of injury in the event of a fall.

Do not operate electrically powered equipment in damp or wet locations.

Never operate this equipment if it has a damaged cord or plug, if it is not working properly, or if it has been dropped, damaged, or exposed to water. Call for service immediately if any of these conditions exist.

Maintain the equipment to keep it in good working condition, as described in the Maintenance section of the assembly and maintenance guide. Inspect the equipment for incorrect, worn, or loose components, and then correct, replace or tighten prior to use.

If you plan to move the equipment, obtain help and use proper lifting techniques.

Equipment Weight Restrictions: Do not use the treadmill if you weigh more than 500 pounds (225 kg). If you weigh more than 350 pounds (160 kg), do not run on the treadmill. For all other fitness equipment, the weight limit is 350 pounds (160 kg).

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Operating and Maintaining the P20 Console Page Page Trademark Note Edition InformationIntellectual Property Notice Safety Precautions Important Safety InstructionsOperating and Maintaining the P20 Console Important Safety Instructions Product Recycling and Disposal Hazardous Materials and Proper DisposalRadio Frequency Interference RFI Safety Approvals for Cardiovascular EquipmentRegulatory Notices for Cardiovascular Exercise Equipment Cardiovascular Type EquipmentEuropean Applications Industry CanadaElectrical Recommendations 120 V and 240 V Treadmills North American 120-volt, 20-amp power receptacleIEC-320 C13 and C14 plugs Obtaining ServiceTable of Contents Operating and Maintaining the P20 Console Activating the Console for Self-Powered Equipment Activating the Console for Self-Powered EquipmentGetting Started Optional Use of the Power Adapter Setting Up the Console Identifying Parts of the Console  Press GO or Programs to Start scrolls in the text display Welcome StateInput Up Enter Viewing the Odometer Informational MenuOdometer To view the odometer informational menuEvent Log Event Description of Event Number Hour MeterBase Software Viewing the Club Settings MenuBoot Software Lower SoftwareMax Pause Time Club Setting Values LanguageTo view the Club Settings menu Max Cool Down TimeUnit of Measure Default Workout TimeMax Resistance Bike, AMT Max Workout TimePrograms Enter Input Down Input Up Safety Code TreadmillSegments EFX Introducing Users to the P20 Console Using the Touch Heart Rate FeatureHeart rate target zones To use a chest strap transmitter Using a Chest Strap TransmitterRestart switch Using the Treadmill Safety ClipTreadmill Auto Stop Automatic Stop Function Attaching the safety clipTo test your heart rate Using SmartRateStarting a Workout To begin using a program Starting a Preset Programmed WorkoutEntering Personal Data Terminating Data Entry Pausing and Restarting an Exercise SessionTo enter personal data Pending Shutdown Self-Powered Equipment Paused Externally Powered EquipmentEnding a Session Controlled Metrics Understanding MetricsOperating and Maintaining the P20 Console Manual ProgramsInterval 1-1 and Interval Weight LossHill Climb Basic Heart Rate ControlRandom Cross CountryAerobic Cleaning the Console and Display MaintenanceTo remove dust and dirt from the console Operating and Maintaining the P20 Console Page Precor Incorporated Assembling and Maintaining Elliptical Fitness Crosstrainers Page Page 300711-341 rev G Important Safety Instructions Page Important Safety Instructions Educating Users Regulatory Notices for the Rfid Module Expressly approved by the manufacturer PVS and P80 Regulatory Notice Expressly approved by Precor could void Obtaining Service Obtaining Updated Documentation Assembling the EFX Commercial Cardiovascular Equipment Limited Warranty Assembling the EFX To prepare the EFX for assemblyHardware Kit not to scale Installation RequirementsButtonhead screws To begin assembly Performing the AssemblyRequired Tools Thread cable through upright support EFX cable path Lift cover replacement Rear view of console attachment To mount the center column support on the frameCenter column support attachment To tighten the fasteners properlyTighten the back fasteners on the upright supports To attach the upper body handlebars To attach the water bottle holderUpper body handlebar attachment detail Link arm attachment To attach the upright support covers and pivot arm capsPivot arm cap attachment To level the unit Leveling the EFXBreaking in the Equipment Threading the Cable Assembly P80 Installing the ConsoleRemoving the access cover from the P80 console To thread the cable assemblyConsole positioning on base unit Cable connections, P80 console Connecting Cables P80P80 internal cable connections Cable Connector Type Circuit To connect the television cable Connecting the Television CableConnecting the Ethernet and base unit data cables Connecting the Ethernet and Base Unit Data CablesConnecting the Power Cable Connecting the Heart Rate Sensor CableThreading the Cable Assembly P30 and P20 Completing the Console Installation P80To complete the installation Console positioning on base unit Cable connections, P30 console Connecting Cables P30P30 internal cable connections Cable Connector Type Connecting Cables P20 Verifying That the Heart Rate Display Is Operational Completing the Console Installation P30 and P20To verify that the heart rate display is operational Daily Cleaning Daily Inspection Monthly Maintenance Weekly MaintenanceMoving the Equipment Storing the Chest StrapLong-Term Storage Rate of Motion Self-Powered FeaturesInformational Displays Prior to Shutdown Symptoms of a Low BatteryOptional Power Adapter Kit Using the Optional Power AdapterReplacing the Battery Limited Warranty Commercial Cardiovascular Equipment Limited WarrantyWarranty Periods and Coverage Conditions and Restrictions Exclusive Remedies Complete this portion and keep for your records Exclusion of Consequential and Incidental DamagesPage EFX 8x5 PAG/OM 300711-341 rev G, en
Related manuals
Manual 104 pages 61.47 Kb

p20 specifications

The Precor P20 is an innovative treadmill that combines advanced technology with user-friendly features to enhance the workout experience for both beginners and fitness enthusiasts. Recognized for its durability and performance, the P20 is designed for both home and commercial use, making it a versatile choice for various fitness environments.

One of the standout features of the Precor P20 is its robust motor, which is designed to provide a smooth and consistent performance. The motor delivers a range of speeds, allowing users to tailor their workouts according to their fitness levels and goals. With a maximum speed of up to 12 mph, users can easily switch between a light walk and an intense run with ease.

Another key characteristic of the P20 is its state-of-the-art cushioning system. The Precision Stride™ technology absorbs impact, reducing stress on joints and providing a more comfortable running surface. This feature is particularly beneficial for individuals who may be prone to injuries or those looking to maintain their joint health over time.

The Precor P20 also incorporates an intuitive console that offers a user-friendly interface. This console features quick-access buttons for speed and incline adjustment, making it convenient for users to transition between different workout intensities. Additionally, the built-in workouts provide a variety of options, from interval training to heart rate control programs, catering to all fitness levels.

Connectivity is another notable aspect of the P20. The treadmill is equipped with Bluetooth technology, allowing users to sync their fitness devices and track their progress seamlessly. This connectivity also enables users to access various fitness apps, providing a more interactive and engaging workout experience.

Moreover, the Precor P20 features a sturdy frame and a large running surface, making it suitable for users of different heights and sizes. The high-quality materials used in the construction ensure longevity and reliability, making it a worthwhile investment for anyone serious about their fitness journey.

In conclusion, the Precor P20 is a well-rounded treadmill that excels in performance, comfort, and connectivity. With its powerful motor, advanced cushioning system, and user-friendly interface, it stands out among treadmills in its class. Whether you're looking to enhance your home gym or provide a top-notch option in a commercial setting, the Precor P20 is an excellent choice that meets the demands of modern fitness enthusiasts.
Top Page Image Contents